[U-Boot] [PATCH] apalis_imx6: fix broken fsl_esdhc_imx conversion

Ricardo Salveti ricardo at foundries.io
Mon Sep 2 21:12:02 UTC 2019


Commit e37ac717d796 ("Convert to use fsl_esdhc_imx for i.MX platforms")
converted FSL_ESDHC to FSL_ESDHC_IMX, but the config check for
apalis_imx6 wasn't updated accordantly.

Signed-off-by: Ricardo Salveti <ricardo at foundries.io>
---
 board/toradex/apalis_imx6/apalis_imx6.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/board/toradex/apalis_imx6/apalis_imx6.c b/board/toradex/apalis_imx6/apalis_imx6.c
index ef668fcedc..89680da53f 100644
--- a/board/toradex/apalis_imx6/apalis_imx6.c
+++ b/board/toradex/apalis_imx6/apalis_imx6.c
@@ -93,7 +93,7 @@ iomux_v3_cfg_t const uart1_pads_dte[] = {
 	MX6_PAD_CSI0_DAT11__UART1_TX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL),
 };
 
-#if defined(CONFIG_FSL_ESDHC) && defined(CONFIG_SPL_BUILD)
+#if defined(CONFIG_FSL_ESDHC_IMX) && defined(CONFIG_SPL_BUILD)
 /* Apalis MMC1 */
 iomux_v3_cfg_t const usdhc1_pads[] = {
 	MX6_PAD_SD1_CLK__SD1_CLK   | MUX_PAD_CTRL(USDHC_PAD_CTRL),
@@ -290,7 +290,7 @@ int board_ehci_hcd_init(int port)
 }
 #endif
 
-#if defined(CONFIG_FSL_ESDHC) && defined(CONFIG_SPL_BUILD)
+#if defined(CONFIG_FSL_ESDHC_IMX) && defined(CONFIG_SPL_BUILD)
 /* use the following sequence: eMMC, MMC1, SD1 */
 struct fsl_esdhc_cfg usdhc_cfg[CONFIG_SYS_FSL_USDHC_NUM] = {
 	{USDHC3_BASE_ADDR},
-- 
2.23.0



More information about the U-Boot mailing list