[U-Boot] [PATCH] apalis_imx6: fix broken fsl_esdhc_imx conversion

[Peng Fan]

> Subject: [PATCH] apalis_imx6: fix broken fsl_esdhc_imx conversion
> 
> Commit e37ac717d796 ("Convert to use fsl_esdhc_imx for i.MX platforms")
> converted FSL_ESDHC to FSL_ESDHC_IMX, but the config check for
> apalis_imx6 wasn't updated accordantly.
> 
> Signed-off-by: Ricardo Salveti <ricardo at foundries.io>
> ---
>  board/toradex/apalis_imx6/apalis_imx6.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/board/toradex/apalis_imx6/apalis_imx6.c
> b/board/toradex/apalis_imx6/apalis_imx6.c
> index ef668fcedc..89680da53f 100644
> --- a/board/toradex/apalis_imx6/apalis_imx6.c
> +++ b/board/toradex/apalis_imx6/apalis_imx6.c
> @@ -93,7 +93,7 @@ iomux_v3_cfg_t const uart1_pads_dte[] = {
>  	MX6_PAD_CSI0_DAT11__UART1_TX_DATA |
> MUX_PAD_CTRL(UART_PAD_CTRL),  };
> 
> -#if defined(CONFIG_FSL_ESDHC) && defined(CONFIG_SPL_BUILD)
> +#if defined(CONFIG_FSL_ESDHC_IMX) && defined(CONFIG_SPL_BUILD)
>  /* Apalis MMC1 */
>  iomux_v3_cfg_t const usdhc1_pads[] = {
>  	MX6_PAD_SD1_CLK__SD1_CLK   |
> MUX_PAD_CTRL(USDHC_PAD_CTRL),
> @@ -290,7 +290,7 @@ int board_ehci_hcd_init(int port)  }  #endif
> 
> -#if defined(CONFIG_FSL_ESDHC) && defined(CONFIG_SPL_BUILD)
> +#if defined(CONFIG_FSL_ESDHC_IMX) && defined(CONFIG_SPL_BUILD)
>  /* use the following sequence: eMMC, MMC1, SD1 */  struct fsl_esdhc_cfg
> usdhc_cfg[CONFIG_SYS_FSL_USDHC_NUM] = {
>  	{USDHC3_BASE_ADDR},

Reviewed-by: Peng Fan <peng.fan at nxp.com>

> --
> 2.23.0