[PATCH v4 1/8] mmc: ca_dw_mmc: add DesignWare based DM support for CAxxxx SoCs

Alex Nemirovsky Alex.Nemirovsky at cortina-access.com
Thu Apr 2 08:27:06 CEST 2020


That’s odd. I didn’t get the memo. :)

> On Apr 1, 2020, at 11:23 PM, Jaehoon Chung <jh80.chung at samsung.com> wrote:
> 
> Hi,
> 
> On 3/31/20 8:51 AM, Alex Nemirovsky wrote:
>> From: Arthur Li <arthur.li at cortina-access.com>
>> 
>> Initial DesignWare based DM support for Cortina Access CAxxxx SoCs.
>> 
>> Signed-off-by: Arthur Li <arthur.li at cortina-access.com>
>> Signed-off-by: Alex Nemirovsky <alex.nemirovsky at cortina-access.com>
>> CC: Peng Fan <peng.fan at nxp.com>
> 
> It seems that it has already applied to u-boot?
> If i missed something, let me know, plz.
> 
> Best Regards,
> Jaehoon Chung
> 
>> 
>> ---
>> 
>> Changes in v4:
>> - Rename DT compatible name
>> - Remove uneccessary if-statement to support 8-bit buswidth
>> - Remove redundant error msg
>> - Use symbolic constants in switch statement
>> 
>> Changes in v3: None
>> Changes in v2:
>> - Add I2C controller
>> - Add LED controller
>> - Add SPI NAND and NOR controller
>> 
>> MAINTAINERS             |   2 +
>> drivers/mmc/Kconfig     |  11 ++++
>> drivers/mmc/Makefile    |   1 +
>> drivers/mmc/ca_dw_mmc.c | 171 ++++++++++++++++++++++++++++++++++++++++++++++++
>> 4 files changed, 185 insertions(+)
>> create mode 100644 drivers/mmc/ca_dw_mmc.c
>> 
>> diff --git a/MAINTAINERS b/MAINTAINERS
>> index 82e4159..bb45d3c 100644
>> --- a/MAINTAINERS
>> +++ b/MAINTAINERS
>> @@ -180,6 +180,7 @@ F:	board/cortina/common/
>> F:	drivers/gpio/cortina_gpio.c
>> F:	drivers/watchdog/cortina_wdt.c
>> F:	drivers/serial/serial_cortina.c
>> +F:	drivers/mmc/ca_dw_mmc.c
>> 
>> ARM/CZ.NIC TURRIS MOX SUPPORT
>> M:	Marek Behun <marek.behun at nic.cz>
>> @@ -670,6 +671,7 @@ F:	board/cortina/common/
>> F:	drivers/gpio/cortina_gpio.c
>> F:	drivers/watchdog/cortina_wdt.c
>> F:	drivers/serial/serial_cortina.c
>> +F:	drivers/mmc/ca_dw_mmc.c
>> 
>> MIPS MSCC
>> M:	Gregory CLEMENT <gregory.clement at bootlin.com>
>> diff --git a/drivers/mmc/Kconfig b/drivers/mmc/Kconfig
>> index 2f0eedc..bb38787 100644
>> --- a/drivers/mmc/Kconfig
>> +++ b/drivers/mmc/Kconfig
>> @@ -205,6 +205,17 @@ config MMC_DW
>> 	  block, this provides host support for SD and MMC interfaces, in both
>> 	  PIO, internal DMA mode and external DMA mode.
>> 
>> +config MMC_DW_CORTINA
>> +	bool "Cortina specific extensions for Synopsys DW Memory Card Interface"
>> +	depends on DM_MMC
>> +	depends on MMC_DW
>> +	depends on BLK
>> +	default n
>> +	help
>> +	  This selects support for Cortina SoC specific extensions to the
>> +	  Synopsys DesignWare Memory Card Interface driver. Select this option
>> +	  for platforms based on Cortina CAxxxx Soc's.
>> +
>> config MMC_DW_EXYNOS
>> 	bool "Exynos specific extensions for Synopsys DW Memory Card Interface"
>> 	depends on ARCH_EXYNOS
>> diff --git a/drivers/mmc/Makefile b/drivers/mmc/Makefile
>> index 9c1f8e5..615b724 100644
>> --- a/drivers/mmc/Makefile
>> +++ b/drivers/mmc/Makefile
>> @@ -20,6 +20,7 @@ endif
>> obj-$(CONFIG_ARM_PL180_MMCI) += arm_pl180_mmci.o
>> obj-$(CONFIG_MMC_DAVINCI)		+= davinci_mmc.o
>> obj-$(CONFIG_MMC_DW)			+= dw_mmc.o
>> +obj-$(CONFIG_MMC_DW_CORTINA)		+= ca_dw_mmc.o
>> obj-$(CONFIG_MMC_DW_EXYNOS)		+= exynos_dw_mmc.o
>> obj-$(CONFIG_MMC_DW_K3)			+= hi6220_dw_mmc.o
>> obj-$(CONFIG_MMC_DW_ROCKCHIP)		+= rockchip_dw_mmc.o
>> diff --git a/drivers/mmc/ca_dw_mmc.c b/drivers/mmc/ca_dw_mmc.c
>> new file mode 100644
>> index 0000000..198c41f
>> --- /dev/null
>> +++ b/drivers/mmc/ca_dw_mmc.c
>> @@ -0,0 +1,171 @@
>> +// SPDX-License-Identifier: GPL-2.0+
>> +/*
>> + * (C) Copyright 2019 Cortina Access
>> + * Arthur Li <arthur.li at cortina-access.com>
>> + */
>> +
>> +#include <common.h>
>> +#include <dwmmc.h>
>> +#include <fdtdec.h>
>> +#include <linux/libfdt.h>
>> +#include <malloc.h>
>> +#include <errno.h>
>> +#include <dm.h>
>> +#include <mapmem.h>
>> +
>> +#define SD_CLK_SEL_MASK (0x3)
>> +#define SD_DLL_DEFAULT  (0x143000)
>> +#define SD_SCLK_MAX (200000000)
>> +
>> +#define SD_CLK_SEL_200MHZ (0x2)
>> +#define SD_CLK_SEL_100MHZ (0x1)
>> +#define SD_CLK_SEL_50MHZ (0x0)
>> +
>> +#define IO_DRV_SD_DS_OFFSET (16)
>> +#define IO_DRV_SD_DS_MASK   (0xff << IO_DRV_SD_DS_OFFSET)
>> +
>> +#define MIN_FREQ (400000)
>> +
>> +DECLARE_GLOBAL_DATA_PTR;
>> +
>> +struct ca_mmc_plat {
>> +	struct mmc_config cfg;
>> +	struct mmc mmc;
>> +};
>> +
>> +struct ca_dwmmc_priv_data {
>> +	struct dwmci_host host;
>> +	void __iomem *sd_dll_reg;
>> +	void __iomem *io_drv_reg;
>> +	u8 ds;
>> +};
>> +
>> +static void ca_dwmci_clksel(struct dwmci_host *host)
>> +{
>> +	struct ca_dwmmc_priv_data *priv = host->priv;
>> +	u32 val = readl(priv->sd_dll_reg);
>> +
>> +	val &= ~SD_CLK_SEL_MASK;
>> +	if (host->bus_hz >= 200000000)
>> +		val |= SD_CLK_SEL_200MHZ;
>> +	else if (host->bus_hz >= 100000000)
>> +		val |= SD_CLK_SEL_100MHZ;
>> +
>> +	writel(val, priv->sd_dll_reg);
>> +}
>> +
>> +static void ca_dwmci_board_init(struct dwmci_host *host)
>> +{
>> +	struct ca_dwmmc_priv_data *priv = host->priv;
>> +	u32 val = readl(priv->io_drv_reg);
>> +
>> +	writel(SD_DLL_DEFAULT, priv->sd_dll_reg);
>> +
>> +	val &= ~IO_DRV_SD_DS_MASK;
>> +	if (priv && priv->ds)
>> +		val |= priv->ds << IO_DRV_SD_DS_OFFSET;
>> +	writel(val, priv->io_drv_reg);
>> +}
>> +
>> +unsigned int ca_dwmci_get_mmc_clock(struct dwmci_host *host, uint freq)
>> +{
>> +	struct ca_dwmmc_priv_data *priv = host->priv;
>> +	u8 sd_clk_sel = readl(priv->sd_dll_reg) & SD_CLK_SEL_MASK;
>> +	u8 clk_div;
>> +
>> +	switch (sd_clk_sel) {
>> +	case SD_CLK_SEL_50MHZ:
>> +		clk_div = 4;
>> +		break;
>> +	case SD_CLK_SEL_100MHZ:
>> +		clk_div = 2;
>> +		break;
>> +	default:
>> +		clk_div = 1;
>> +	}
>> +
>> +	return SD_SCLK_MAX / clk_div / (host->div + 1);
>> +}
>> +
>> +static int ca_dwmmc_ofdata_to_platdata(struct udevice *dev)
>> +{
>> +	struct ca_dwmmc_priv_data *priv = dev_get_priv(dev);
>> +	struct dwmci_host *host = &priv->host;
>> +	u32 tmp;
>> +
>> +	host->name = dev->name;
>> +	host->dev_index = 0;
>> +
>> +	host->buswidth = dev_read_u32_default(dev, "bus-width", 1);
>> +	host->bus_hz = dev_read_u32_default(dev, "max-frequency", 50000000);
>> +	priv->ds = dev_read_u32_default(dev, "io_ds", 0x33);
>> +	host->fifo_mode = dev_read_bool(dev, "fifo-mode");
>> +
>> +	dev_read_u32(dev, "sd_dll_ctrl", &tmp);
>> +	priv->sd_dll_reg = map_sysmem((uintptr_t)tmp, sizeof(uintptr_t));
>> +	if (!priv->sd_dll_reg)
>> +		return -EINVAL;
>> +
>> +	dev_read_u32(dev, "io_drv_ctrl", &tmp);
>> +	priv->io_drv_reg = map_sysmem((uintptr_t)tmp, sizeof(uintptr_t));
>> +	if (!priv->io_drv_reg)
>> +		return -EINVAL;
>> +
>> +	host->ioaddr = dev_read_addr_ptr(dev);
>> +	if (!host->ioaddr)
>> +		return -EINVAL;
>> +
>> +	host->priv = priv;
>> +
>> +	return 0;
>> +}
>> +
>> +struct dm_mmc_ops ca_dwmci_dm_ops;
>> +
>> +static int ca_dwmmc_probe(struct udevice *dev)
>> +{
>> +	struct ca_mmc_plat *plat = dev_get_platdata(dev);
>> +	struct mmc_uclass_priv *upriv = dev_get_uclass_priv(dev);
>> +	struct ca_dwmmc_priv_data *priv = dev_get_priv(dev);
>> +	struct dwmci_host *host = &priv->host;
>> +
>> +	memcpy(&ca_dwmci_dm_ops, &dm_dwmci_ops, sizeof(struct dm_mmc_ops));
>> +
>> +	dwmci_setup_cfg(&plat->cfg, host, host->bus_hz, MIN_FREQ);
>> +	if (host->buswidth == 1)
>> +		(&plat->cfg)->host_caps &= ~(MMC_MODE_8BIT | MMC_MODE_4BIT);
>> +
>> +	host->mmc = &plat->mmc;
>> +	host->mmc->priv = &priv->host;
>> +	upriv->mmc = host->mmc;
>> +	host->mmc->dev = dev;
>> +	host->clksel = ca_dwmci_clksel;
>> +	host->board_init = ca_dwmci_board_init;
>> +	host->get_mmc_clk = ca_dwmci_get_mmc_clock;
>> +
>> +	return dwmci_probe(dev);
>> +}
>> +
>> +static int ca_dwmmc_bind(struct udevice *dev)
>> +{
>> +	struct ca_mmc_plat *plat = dev_get_platdata(dev);
>> +
>> +	return dwmci_bind(dev, &plat->mmc, &plat->cfg);
>> +}
>> +
>> +static const struct udevice_id ca_dwmmc_ids[] = {
>> +	{ .compatible = "cortina,ca-mmc" },
>> +	{ }
>> +};
>> +
>> +U_BOOT_DRIVER(ca_dwmmc_drv) = {
>> +	.name		= "cortina_dwmmc",
>> +	.id		= UCLASS_MMC,
>> +	.of_match	= ca_dwmmc_ids,
>> +	.ofdata_to_platdata = ca_dwmmc_ofdata_to_platdata,
>> +	.bind		= ca_dwmmc_bind,
>> +	.ops		= &ca_dwmci_dm_ops,
>> +	.probe		= ca_dwmmc_probe,
>> +	.priv_auto_alloc_size	= sizeof(struct ca_dwmmc_priv_data),
>> +	.platdata_auto_alloc_size = sizeof(struct ca_mmc_plat),
>> +};
>> 
> 



More information about the U-Boot mailing list