[PATCH v4] ARM: imx6: DHCOM i.MX6 PDK: Convert to DM_ETH

[sbabic at denx.de]

> Use DM_ETH instead of legacy networking.  Add VIO as a fixed regulator
> to the relevant device-trees and augment the FEC node with properties
> for the reset GPIO.
> It should be noted that the relevant properties for the reset GPIO
> already exist in the PHY node (reset-gpios, reset-delay-us,
> reset-post-delay-us) but U-Boot currently ignores those and only
> supports the bus-level reset properties in the FEC node
> (phy-reset-gpios, phy-reset-duration, phy-reset-post-delay).
> Signed-off-by: Harald Seiler <hws at denx.de>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================