ZynqMP boot: no messages from SPL other than "Debug uart enabled"

[Major A]

Hi Michal,

Yes, I did.  The Petalinux image from here:

 
https://xilinx-wiki.atlassian.net/wiki/spaces/A/pages/18841937/Zynq+UltraScale+MPSoC+Ubuntu+part+2+-+Building+and+Running+the+Ubuntu+Desktop+From+Sources

works fine.

Cheers,

   András


On 30/04/2020 13:03, Michal Simek wrote:
> hi,
> 
> that's quite weird. Did you try any petalinux bsp and boot petalinux
> boot.bin on that board to make sure that board is fine?
> 
> M
> 
> On 30. 04. 20 13:01, Major A wrote:
>> Hi Michal,
>>
>> Sorry I misunderstood your message, and I didn't spot the attached
>> files.  Now I booted with those two files, there's no output on the
>> UARTs whatsoever.  Is there anything else I can try?
>>
>> Cheers,
>>
>>    András
>>
>>
>> On 30/04/2020 12:33, Michal Simek wrote:
>>> Hi,
>>>
>>> On 30. 04. 20 12:19, Major A wrote:
>>>> Hi Michal,
>>>>
>>>>> can you please try these files in SD boot mode?
>>>>
>>>> Done, here are two logs, both in SD boot mode.
>>>>
>>>> First, log.sd is with SD card inserted (with the image files that
>>>> apparently refuse to work other than the early UART message).
>>>>
>>>> The other file, log.no-sd, is with no card inserted.
>>>
>>> we don't understand each other. I sent you boot.bin and image.itb. Just
>>> copy them to SD card, switch board to sd boot mode and power it up.
>>>
>>> Thanks,
>>> Michal
>>>
>