ZynqMP boot: no messages from SPL other than "Debug uart enabled"

[Michal Simek]

hi,

that's quite weird. Did you try any petalinux bsp and boot petalinux
boot.bin on that board to make sure that board is fine?

M

On 30. 04. 20 13:01, Major A wrote:
> Hi Michal,
> 
> Sorry I misunderstood your message, and I didn't spot the attached
> files.  Now I booted with those two files, there's no output on the
> UARTs whatsoever.  Is there anything else I can try?
> 
> Cheers,
> 
>   András
> 
> 
> On 30/04/2020 12:33, Michal Simek wrote:
>> Hi,
>>
>> On 30. 04. 20 12:19, Major A wrote:
>>> Hi Michal,
>>>
>>>> can you please try these files in SD boot mode?
>>>
>>> Done, here are two logs, both in SD boot mode.
>>>
>>> First, log.sd is with SD card inserted (with the image files that
>>> apparently refuse to work other than the early UART message).
>>>
>>> The other file, log.no-sd, is with no card inserted.
>>
>> we don't understand each other. I sent you boot.bin and image.itb. Just
>> copy them to SD card, switch board to sd boot mode and power it up.
>>
>> Thanks,
>> Michal
>>