[V2 3/3] ARM: mvebu: ClearFog make sure that SATA and UART images are buildable

[dgilmore at redhat.com]

From: Dennis Gilmore <dennis at ausil.us>

SATA and UART ClearFog imaages are not buildable as ENV_SECT_SIZE is not defined
set values for both possible targets

Signed-off-by: Dennis Gilmore <dennis at ausil.us>
---
 board/solidrun/clearfog/Kconfig | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/board/solidrun/clearfog/Kconfig b/board/solidrun/clearfog/Kconfig
index e8c3f53d84..cf95258090 100644
--- a/board/solidrun/clearfog/Kconfig
+++ b/board/solidrun/clearfog/Kconfig
@@ -50,9 +50,9 @@ config ENV_OFFSET
 config ENV_SECT_SIZE
 	hex "Environment Sector-Size"
 	# Use SPI flash erase block size of 4 KiB
-	default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI
+	default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI || MVEBU_SPL_BOOT_DEVICE_SATA
 	# Use optimistic 64 KiB erase block, will vary between actual media
-	default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC
+	default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC || MVEBU_SPL_BOOT_DEVICE_UART
 
 config SYS_SPI_U_BOOT_OFFS
 	hex "address of u-boot payload in SPI flash"
-- 
2.28.0