[PATCH] ARM: socfpga: Add initial support for the ABB SECU board

[Holger Brunck]

> >>> In message <20200217173249.4805-1-marex at denx.de> you wrote:
> >>>>
> >>>>  board/keymile/Kconfig                   |  11 +-
> >>>>  board/keymile/common/ivm.c              |  18 +-
> >>>>  board/keymile/secu1/Makefile            |   7 +
> >>>>  board/keymile/secu1/qts/iocsr_config.h  | 694
> >>>> ++++++++++++++++++++++++
> board/keymile/secu1/qts/pinmux_config.h
> >> | 218 ++++++++
> >>>>  board/keymile/secu1/qts/pll_config.h    |  83 +++
> >>>>  board/keymile/secu1/qts/sdram_config.h  | 327 +++++++++++
> >>>>  board/keymile/secu1/socfpga.c           |  67 +++
> >>> ...
> >>>> +    select VENDOR_KM
> >>>
> >>> Would it make sense to rename keymile -> abb (or abb-ch) here (ditto
> >>> for KM in the config options / macro names) ?
> >>
> >> This is more of a question for Holger, but I agree the renaming
> >> should eventually happen to align it with current state of things.
> >
> > yes I have it on my list to rename this folder to wcom (wiredcom)  or wcom-
> abb.
> > But this goes for all the boards in this folder and not only secu. But
> > until know I didn't find the right time to do it as we have currently
> > several activities ongoing for u-boot (re-aligning other boards and migrating
> PPC to DTS).
> >
> > I assume SECU goes for v2020.07 as we are too late for v2020.04 or?  I
> > think I can spend some time for the next merge window to tackle this
> > folder issue for all boards and then we rebase and adapt this  patch.
> 
> Boards and drivers which are self-contained can apparently go in even during
> RC cycle.

ok. I prepared a patch to tackle the renaming topic and will upload it. Let's see what
gets in first. We can then rebase this patch if necessary.

Best regards
Holger