[PATCH] ARM: socfpga: Add initial support for the ABB SECU board

[Marek Vasut]

On 2/18/20 8:47 AM, Holger Brunck wrote:
> Hi Marek and Wolfgang,
> 
>>> In message <20200217173249.4805-1-marex at denx.de> you wrote:
>>>>
>>>>  board/keymile/Kconfig                   |  11 +-
>>>>  board/keymile/common/ivm.c              |  18 +-
>>>>  board/keymile/secu1/Makefile            |   7 +
>>>>  board/keymile/secu1/qts/iocsr_config.h  | 694
>>>> ++++++++++++++++++++++++  board/keymile/secu1/qts/pinmux_config.h
>> | 218 ++++++++
>>>>  board/keymile/secu1/qts/pll_config.h    |  83 +++
>>>>  board/keymile/secu1/qts/sdram_config.h  | 327 +++++++++++
>>>>  board/keymile/secu1/socfpga.c           |  67 +++
>>> ...
>>>> +    select VENDOR_KM
>>>
>>> Would it make sense to rename keymile -> abb (or abb-ch) here (ditto
>>> for KM in the config options / macro names) ?
>>
>> This is more of a question for Holger, but I agree the renaming should
>> eventually happen to align it with current state of things.
> 
> yes I have it on my list to rename this folder to wcom (wiredcom)  or wcom-abb.
> But this goes for all the boards in this folder and not only secu. But until know
> I didn't find the right time to do it as we have currently several activities ongoing for
> u-boot (re-aligning other boards and migrating PPC to DTS).
> 
> I assume SECU goes for v2020.07 as we are too late for v2020.04 or?  I think I can
> spend some time for the next merge window to tackle this folder issue for all boards
> and then we rebase and adapt this  patch.

Boards and drivers which are self-contained can apparently go in even
during RC cycle.