[PATCH 4/5] ARM: dts: stm32: Add missing ETHCK clock to ethernet node

Patrice CHOTARD patrice.chotard at st.com
Mon Jan 13 13:50:09 CET 2020


Hi Marek

Adding Christophe Roullier


On 1/10/20 1:28 AM, Marek Vasut wrote:
> Add missing 'eth-ck' clock to the ethernet node. These clock are used to
> generate external clock signal for the PHY in case 'st,eth_ref_clk_sel'
> is specified.
>
> Signed-off-by: Marek Vasut <marex at denx.de>
> Cc: Patrick Delaunay <patrick.delaunay at st.com>
> Cc: Patrice Chotard <patrice.chotard at st.com>
> ---
>  arch/arm/dts/stm32mp157c.dtsi | 2 ++
>  1 file changed, 2 insertions(+)
>
> diff --git a/arch/arm/dts/stm32mp157c.dtsi b/arch/arm/dts/stm32mp157c.dtsi
> index 6c670cf9a3..41aea75213 100644
> --- a/arch/arm/dts/stm32mp157c.dtsi
> +++ b/arch/arm/dts/stm32mp157c.dtsi
> @@ -1404,11 +1404,13 @@
>  			clock-names = "stmmaceth",
>  				      "mac-clk-tx",
>  				      "mac-clk-rx",
> +				      "eth-ck",
>  				      "ethstp",
>  				      "syscfg-clk";
>  			clocks = <&rcc ETHMAC>,
>  				 <&rcc ETHTX>,
>  				 <&rcc ETHRX>,
> +				 <&rcc ETHCK_K>,
>  				 <&rcc ETHSTP>,
>  				 <&rcc SYSCFG>;
>  			st,syscon = <&syscfg 0x4>;

Adding this clock is a particular case, it should be added in the board DT file, not in the SoC DT one.

Our ethernet expert ( Christophe  -in CC) is surprised that you don't need the following pin:

 <STM32_PINMUX('G', 8, AF2)>, /* ETH_RMII_ETHCK */

To confirm, can you describe your ethernet config ?

Thanks


More information about the U-Boot mailing list