[PATCH 1/5] ARM: stm32: Permit multiple board targets

Patrick DELAUNAY patrick.delaunay at st.com
Mon Jan 13 16:07:17 CET 2020


Hi Marek,

> From: Marek Vasut <marex at denx.de>
> Sent: lundi 13 janvier 2020 12:08
> 
> On 1/13/20 11:58 AM, Patrick DELAUNAY wrote:
> > Hi Marek,
> >
> >> From: Marek Vasut <marex at denx.de>
> >> Sent: vendredi 10 janvier 2020 01:29
> >>
> >> Setting TARGET_STM32MP1 in Kconfig always forces SYS_BOARD,
> >> SYS_VENDOR and SYS_CONFIG_NAME to values set by the ST reference
> >> platforms. Allow changing that by pulling out the
> >> TARGET_STM32MP157C_DK2 and making the ST reference platform settings
> >> conditional on
> >> TARGET_STM32MP157C_DK2 .
> >> Other platforms can now define a different TARGET_ and thus override
> >> the SYS_ settings in their Kconfig.
> >
> > Reviewed-by: Patrick Delaunay <patrick.delaunay at st.com>
> >
> > It seens my configuration between SOC (STM32MP15x) and BOARD is not
> clean...
> >
> > So I prepare a patchset to change it.
> > But I will apply it after your serie...
> > to avoid regression on your board
> >
> > Regards Patrick
> 
> Can you apply whatever you feel applicable from the series I posted and push it to
> some git repo, so I don't have to reset all things over and over again ?

Sure.

https://gitlab.denx.de/u-boot/custodians/u-boot-stm.git

=> branch master : the paches accepted
	[V3] stm32mp1: configs: Make all boot devices in distro boot conditional

	[2/5] ARM: stm32: Allow overriding setup_mac_address()
	
	They will be included in my next pull request 

=> branch next 
	+ my serie  = http://patchwork.ozlabs.org/project/uboot/list/?series=152828
	+ your serie (including my proposals of update)
		http://patchwork.ozlabs.org/project/uboot/list/?series=152293

		[3/5] ARM: stm32: Fill in missing loadaddr
			=> I change address to 0xc2000000

		[5/5] ARM: dts: stm32: Add DH Electronics DHCOM SoM and PDK2 board
			I make a lot of modification after my serie and my review....

		Can you check the delta and tell me if it is working...
			

		NB: no more needed after my serie  => [1/5] ARM: stm32: Permit multiple board targets i

		PS: [4/5] ARM: dts: stm32: Add missing ETHCK clock to ethernet node
			I ma waiting Christophe / kernel feedback....

Patrick


More information about the U-Boot mailing list