[PATCH 1/5] ARM: stm32: Permit multiple board targets

[Marek Vasut]

On 1/13/20 4:07 PM, Patrick DELAUNAY wrote:
> Hi Marek,
> 
>> From: Marek Vasut <marex at denx.de>
>> Sent: lundi 13 janvier 2020 12:08
>>
>> On 1/13/20 11:58 AM, Patrick DELAUNAY wrote:
>>> Hi Marek,
>>>
>>>> From: Marek Vasut <marex at denx.de>
>>>> Sent: vendredi 10 janvier 2020 01:29
>>>>
>>>> Setting TARGET_STM32MP1 in Kconfig always forces SYS_BOARD,
>>>> SYS_VENDOR and SYS_CONFIG_NAME to values set by the ST reference
>>>> platforms. Allow changing that by pulling out the
>>>> TARGET_STM32MP157C_DK2 and making the ST reference platform settings
>>>> conditional on
>>>> TARGET_STM32MP157C_DK2 .
>>>> Other platforms can now define a different TARGET_ and thus override
>>>> the SYS_ settings in their Kconfig.
>>>
>>> Reviewed-by: Patrick Delaunay <patrick.delaunay at st.com>
>>>
>>> It seens my configuration between SOC (STM32MP15x) and BOARD is not
>> clean...
>>>
>>> So I prepare a patchset to change it.
>>> But I will apply it after your serie...
>>> to avoid regression on your board
>>>
>>> Regards Patrick
>>
>> Can you apply whatever you feel applicable from the series I posted and push it to
>> some git repo, so I don't have to reset all things over and over again ?
> 
> Sure.
> 
> https://gitlab.denx.de/u-boot/custodians/u-boot-stm.git
> 
> => branch master : the paches accepted
> 	[V3] stm32mp1: configs: Make all boot devices in distro boot conditional
> 
> 	[2/5] ARM: stm32: Allow overriding setup_mac_address()
> 	
> 	They will be included in my next pull request 
> 
> => branch next 
> 	+ my serie  = http://patchwork.ozlabs.org/project/uboot/list/?series=152828
> 	+ your serie (including my proposals of update)
> 		http://patchwork.ozlabs.org/project/uboot/list/?series=152293
> 
> 		[3/5] ARM: stm32: Fill in missing loadaddr
> 			=> I change address to 0xc2000000
> 
> 		[5/5] ARM: dts: stm32: Add DH Electronics DHCOM SoM and PDK2 board
> 			I make a lot of modification after my serie and my review....
> 
> 		Can you check the delta and tell me if it is working...
> 			
> 
> 		NB: no more needed after my serie  => [1/5] ARM: stm32: Permit multiple board targets i
> 
> 		PS: [4/5] ARM: dts: stm32: Add missing ETHCK clock to ethernet node
> 			I ma waiting Christophe / kernel feedback....
> 

Should be OK, thanks.