[Uboot-stm32] [PATCH] configs: stm32mp1: only support SD card after NOR in bootcmd_stm32mp

Patrice CHOTARD patrice.chotard at st.com
Thu Jul 2 09:08:45 CEST 2020


Hi

On 6/16/20 6:30 PM, Patrick Delaunay wrote:
> In the boot command used in ST boards, bootcmd_stm32mp, only support
> the SD card as second stage, where is found the bootfs with DISTRO.
>
> Signed-off-by: Patrick Delaunay <patrick.delaunay at st.com>
> ---
>
>  include/configs/stm32mp1.h | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
>
> diff --git a/include/configs/stm32mp1.h b/include/configs/stm32mp1.h
> index f271b84a59..baaf2ff89c 100644
> --- a/include/configs/stm32mp1.h
> +++ b/include/configs/stm32mp1.h
> @@ -123,7 +123,7 @@
>   * for serial/usb: execute the stm32prog command
>   * for mmc boot (eMMC, SD card), boot only on the same device
>   * for nand or spi-nand boot, boot with on ubifs partition on UBI partition
> - * for nor boot, use the default order
> + * for nor boot, use SD card = mmc0
>   */
>  #define STM32MP_BOOTCMD "bootcmd_stm32mp=" \
>  	"echo \"Boot over ${boot_device}${boot_instance}!\";" \
> @@ -136,6 +136,8 @@
>  		"if test ${boot_device} = nand ||" \
>  		  " test ${boot_device} = spi-nand ;" \
>  		"then env set boot_targets ubifs0; fi;" \
> +		"if test ${boot_device} = nor;" \
> +		"then env set boot_targets mmc0; fi;" \
>  		"run distro_bootcmd;" \
>  	"fi;\0"
>  

Reviewed-by: Patrice Chotard <patrice.chotard at st.com>

Thanks


More information about the U-Boot mailing list