[PATCH v3 1/6] rock-pi-4: Enable USB3 Host
Jagan Teki
jagan at amarulasolutions.com
Tue Jul 7 15:50:44 CEST 2020
Enable USB3.0 Host support for RockPI-4 boards.
Note that the Upper USB3.0 port is marked as otg and
lower USB3.0 port marked as host, so this below log
capture when USB3.0 mass storage plug in at lower
USB 3.0 port.
Log:
Bus usb at fe380000: USB EHCI 1.00
Bus usb at fe3c0000: USB EHCI 1.00
Bus dwc3: usb maximum-speed not found
Register 2000140 NbrPorts 2
Starting the controller
USB XHCI 1.10
Bus dwc3: usb maximum-speed not found
Register 2000140 NbrPorts 2
Starting the controller
USB XHCI 1.10
scanning bus usb at fe380000 for devices... 1 USB Device(s) found
scanning bus usb at fe3c0000 for devices... 1 USB Device(s) found
scanning bus dwc3 for devices... 1 USB Device(s) found
scanning bus dwc3 for devices... cannot reset port 1!?
2 USB Device(s) found
scanning usb for storage devices... 1 Storage Device(s) found
=> usb tree
USB device tree:
1 Hub (480 Mb/s, 0mA)
u-boot EHCI Host Controller
1 Hub (480 Mb/s, 0mA)
u-boot EHCI Host Controller
1 Hub (5 Gb/s, 0mA)
U-Boot XHCI Host Controller
1 Hub (5 Gb/s, 0mA)
| U-Boot XHCI Host Controller
|
+-2 Mass Storage (5 Gb/s, 224mA)
SanDisk Dual Drive 040130e3ee554b7078843f4eb331646
Cc: Tom Cubie <tom at radxa.com>
Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
Reviewed-by: Kever Yang <kever.yang at rock-chips.com>
---
Changes for v3:
- collect kever review tag
configs/rock-pi-4-rk3399_defconfig | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/configs/rock-pi-4-rk3399_defconfig b/configs/rock-pi-4-rk3399_defconfig
index 0d86fdc895..2487872219 100644
--- a/configs/rock-pi-4-rk3399_defconfig
+++ b/configs/rock-pi-4-rk3399_defconfig
@@ -28,6 +28,7 @@ CONFIG_ENV_IS_IN_MMC=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_ROCKCHIP_GPIO=y
CONFIG_SYS_I2C_ROCKCHIP=y
+CONFIG_MISC=y
CONFIG_MMC_DW=y
CONFIG_MMC_DW_ROCKCHIP=y
CONFIG_MMC_SDHCI=y
@@ -35,11 +36,14 @@ CONFIG_MMC_SDHCI_ROCKCHIP=y
CONFIG_DM_ETH=y
CONFIG_ETH_DESIGNWARE=y
CONFIG_GMAC_ROCKCHIP=y
+CONFIG_PHY_ROCKCHIP_INNO_USB2=y
+CONFIG_PHY_ROCKCHIP_TYPEC=y
CONFIG_PMIC_RK8XX=y
CONFIG_REGULATOR_PWM=y
CONFIG_REGULATOR_RK8XX=y
CONFIG_PWM_ROCKCHIP=y
CONFIG_RAM_RK3399_LPDDR4=y
+CONFIG_DM_RESET=y
CONFIG_BAUDRATE=1500000
CONFIG_DEBUG_UART_SHIFT=2
CONFIG_SYSRESET=y
@@ -48,6 +52,8 @@ CONFIG_USB_XHCI_HCD=y
CONFIG_USB_XHCI_DWC3=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_EHCI_GENERIC=y
+CONFIG_USB_DWC3=y
+CONFIG_USB_DWC3_GENERIC=y
CONFIG_USB_HOST_ETHER=y
CONFIG_USB_ETHER_ASIX=y
CONFIG_USB_ETHER_ASIX88179=y
--
2.25.1
More information about the U-Boot
mailing list