[U-Boot] [PATCH] ARM: socfpga: Remove socfpga_sdram_apply_static_cfg()

[Simon Goldschmidt]

On Mon, Mar 9, 2020 at 1:57 PM Marek Vasut <marex at denx.de> wrote:
>
> On 3/9/20 9:50 AM, Ley Foon Tan wrote:
> > On Thu, Feb 13, 2020 at 2:52 AM Dalon L Westergreen
> > <dalon.westergreen at linux.intel.com> wrote:
> >>
> >> I am reading through this thread, and want to point out that it is not that the
> >> FPGA bridge need be actively used in the fpga, but
> >> rather that this port be configured in the FPGA configuration.  This is an
> >> important distinction, ecery FPGA design that
> >> instantiates the HPS does configure the F2S Bridge.  it drives select pins,
> >> control pins, data pins, etc, on the interface to known values,
> >> and so the apply can always be done as all SoC FPGA designs have the soc
> >> instantiated.  If someone boots the arm, and uses an
> >> FPGA design without having the soc instantiated, it may then cause issues, but i
> >> would argue that is not a supported use
> >> in the first place.
> >>
> >> --dalon
> >>
> >
> > I can reproduce the issue if without setting applycfg bit. Access to
> > F2sdram interface will cause system hang.
> >
> > From the Cyclone 5 Soc datasheet:
> > applycfg - Write with this bit set to apply all the settings loaded in
> > SDR registers to the memory interface. This bit is write-only and
> > always returns 0 if read.
> >
> > Software should set applycfg bit if change any register under SDR
> > register range. SW is allowed to set this bit multiple times, the only
> > condition is SDRAM need to be idle.
> > My suggestion is we add back socfpga_sdram_apply_static_cfg(), but
> > change the sequence to below:
> > writel(iswgrp_handoff[3], &sdr_ctrl->fpgaport_rst);
> > socfpga_sdram_apply_static_cfg();
> >
> > Marek and Simon, are you okay with this? If yes, I will submit patch for this.
>
> The problem was that this was causing weird sporadic hangs on Gen5,
> which is why it was removed. So until there is an explanation for those
> hangs, I'm not really OK with this.

These sporadic hangs you saw were on devices without an FPGA image directly
accessing the SDRAM ports, right?

>
> Maybe the application of static config should happen in SPL, before the
> DRAM is running, or something like that ?

Thinking this further, limiting it to applying in SPL is not a good idea since
that prevents us from implementing different FPGA images/configs by loading a
config later in the boot (i.e. in U-Boot from a FIT-image).

Would it work to make setting this optional, i.e. only write the bit if an FPGA
config actually uses these ports? Then it couldn't lead to problems on other
hardware...

Regards,
Simon