[PATCH v2 05/14] board: ls2088ardb: transition to DM_ETH

[Ioana Ciornei]

In case CONFIG_DM_ETH is enabled, no hardcoding is necessary for
DPAA2 Ethernet devices. Compile out any unnecessary setup when
CONFIG_DM_ETH is activated.
Also, force the PCI devices to be enumerated at probe time.

Signed-off-by: Ioana Ciornei <ioana.ciornei at nxp.com>
---
Changes in v2:
 - used the positive logic (ifdef CONFIG_DM_ETH instead of ifndef)

 board/freescale/ls2080ardb/eth_ls2080rdb.c | 7 +++++++
 board/freescale/ls2080ardb/ls2080ardb.c    | 4 ++++
 2 files changed, 11 insertions(+)

diff --git a/board/freescale/ls2080ardb/eth_ls2080rdb.c b/board/freescale/ls2080ardb/eth_ls2080rdb.c
index b0f276e8397c..f0f6ca53cb05 100644
--- a/board/freescale/ls2080ardb/eth_ls2080rdb.c
+++ b/board/freescale/ls2080ardb/eth_ls2080rdb.c
@@ -23,6 +23,7 @@ DECLARE_GLOBAL_DATA_PTR;
 
 int board_eth_init(bd_t *bis)
 {
+#ifndef CONFIG_DM_ETH
 #if defined(CONFIG_FSL_MC_ENET)
 	int i, interface;
 	struct memac_mdio_info mdio_info;
@@ -99,6 +100,7 @@ int board_eth_init(bd_t *bis)
 
 	cpu_eth_init(bis);
 #endif /* CONFIG_FSL_MC_ENET */
+#endif /* !CONFIG_DM_ETH */
 
 #ifdef CONFIG_PHY_AQUANTIA
 	/*
@@ -112,7 +114,12 @@ int board_eth_init(bd_t *bis)
 	gd->jt->mdio_phydev_for_ethname = mdio_phydev_for_ethname;
 	gd->jt->miiphy_set_current_dev = miiphy_set_current_dev;
 #endif
+
+#ifdef CONFIG_DM_ETH
+	return 0;
+#else
 	return pci_eth_init(bis);
+#endif
 }
 
 #if defined(CONFIG_RESET_PHY_R)
diff --git a/board/freescale/ls2080ardb/ls2080ardb.c b/board/freescale/ls2080ardb/ls2080ardb.c
index 282aaf47fb88..5e2fc7cc9833 100644
--- a/board/freescale/ls2080ardb/ls2080ardb.c
+++ b/board/freescale/ls2080ardb/ls2080ardb.c
@@ -244,6 +244,10 @@ int board_init(void)
 	sec_init();
 #endif
 
+#if !defined(CONFIG_SYS_EARLY_PCI_INIT) && defined(CONFIG_DM_ETH)
+	pci_init();
+#endif
+
 	return 0;
 }
 
-- 
2.17.1