[PATCH v7 00/22] riscv: Add Sipeed Maix support
Sean Anderson
seanga2 at gmail.com
Thu Mar 19 21:53:58 CET 2020
This patch series adds support for Sipeed Maix boards and the Kendryte
K210 CPU. Currently, only the Maix Bit V2.0 is supported, however other
models are similar.
Known Bugs/Limitations:
- Accessing the AI ram hangs, limiting available ram to 6M
- Trying to boot an image with bootm fails with
ERROR: Failed to allocate 0x7d60 bytes below 0x80000000.
To flash u-boot to a maix bit, run
kflash -tp /dev/<your tty here> -B bit_mic u-boot-dtb.bin
Boot output should look like the following:
U-Boot 2020.04-rc2-00087-g2221cc09c1-dirty (Feb 28 2020 - 13:53:09 -0500)
DRAM: 8 MiB
In: serial at 38000000
Out: serial at 38000000
Err: serial at 38000000
=>
Changes for v7:
- Split documentation from other board support
- Split IPI clear from other IPI cleanup
- Rebased onto a clean upstream. Hopefully this fixes any patching
problems.
Changes for v6:
- Remove spi, pinmux, gpio, led, and wdt support --- to be added in separate
patches
- Rebase onto master
- Clear IPIs before enabling them
- Reorganize code so checkpatch errors less
Changes for v5:
- Rebase onto master
- Add pinconf support
- Add gpio support
- Store environment in spi flash
- Group patches by prefix
- Add additional documentation
- Add SMP support
- Add WDT support
Changes for v4:
- Linted several patches
- Updated the copyright year for several files
- Added tests for syscon-reset, simple-pm-bus, and the pll calc_rate function
- Added/updated documentation
- Fixed SPI for the nor flash
- Fixed PLLs not enabling/setting rate properly
- RISCV_PRIV_1_9_1 now (un)defines all diferring CSRs, and also disables VM
- More devicetree changes
Changes for v3:
- Remove patch to set RV64I as default
- Remove patch for a separate sysctl driver
- Split off cpu frequency patch into its own series
- Reorder support/devicetree patches to come last
- Add patch for reset driver
- Add simple-pm-bus for busses with their own clocks
- Add additional documentation
- Reword mcounteren patch to refer to the RISC-V priv spec 1.9.1
- Many devicetree changes
- Switch to "make savedefconfig" to generate the config
Changes for v2:
- Many bugfixes for the device tree
- Modify the config to build without errors
- Add support for keeping internal PLL frequencies in-range
- Fix several rebase-induced artifacts
Sean Anderson (22):
clk: Always use the supplied struct clk
clk: Check that ops of composite clock components exist before calling
clk: Unconditionally recursively en-/dis-able clocks
clk: Fix clk_get_by_* handling of index
clk: Add functions to register CCF clock structs
clk: Add K210 pll support
clk: Add a bypass clock for K210
clk: Add K210 clock support
dm: Add support for simple-pm-bus
dm: Fix error handling for dev_read_addr_ptr
reset: Add generic reset driver
lib: Always set errno in hcreate_r
riscv: Add headers for asm/global_data.h
riscv: Clear pending interrupts before enabling IPIs
riscv: Clean up IPI initialization code
riscv: Add option to support RISC-V privileged spec 1.9
riscv: Allow use of reset drivers
riscv: Try to get cpu frequency from a "clocks" node if it exists
riscv: Enable cpu clock if it is present
riscv: Add device tree for K210 and Sipeed Maix BitM
doc: riscv: Add documentation for Sipeed Maix Bit
riscv: Add Sipeed Maix support
MAINTAINERS | 7 +
arch/riscv/Kconfig | 14 +
arch/riscv/cpu/cpu.c | 15 +
arch/riscv/cpu/start.S | 2 +
arch/riscv/dts/Makefile | 1 +
arch/riscv/dts/k210-maix-bit.dts | 47 ++
arch/riscv/dts/k210.dtsi | 594 +++++++++++++++++
arch/riscv/include/asm/csr.h | 40 ++
arch/riscv/include/asm/global_data.h | 2 +
arch/riscv/include/asm/smp.h | 43 ++
arch/riscv/lib/andes_plic.c | 34 +-
arch/riscv/lib/reset.c | 2 +
arch/riscv/lib/sbi_ipi.c | 5 +
arch/riscv/lib/sifive_clint.c | 33 +-
arch/riscv/lib/smp.c | 56 +-
arch/sandbox/dts/test.dts | 21 +
arch/sandbox/include/asm/clk.h | 1 +
board/sipeed/maix/Kconfig | 48 ++
board/sipeed/maix/MAINTAINERS | 11 +
board/sipeed/maix/Makefile | 5 +
board/sipeed/maix/maix.c | 54 ++
configs/sandbox_defconfig | 3 +
configs/sipeed_maix_bitm_defconfig | 8 +
doc/board/index.rst | 1 +
doc/board/sipeed/index.rst | 9 +
doc/board/sipeed/maix.rst | 298 +++++++++
.../bus/simple-pm-bus.txt | 44 ++
.../mfd/kendryte,k210-sysctl.txt | 33 +
.../reset/syscon-reset.txt | 36 ++
doc/imx/clk/ccf.txt | 63 +-
drivers/clk/Kconfig | 1 +
drivers/clk/Makefile | 1 +
drivers/clk/clk-composite.c | 145 +++--
drivers/clk/clk-divider.c | 62 +-
drivers/clk/clk-fixed-factor.c | 3 +-
drivers/clk/clk-gate.c | 44 +-
drivers/clk/clk-mux.c | 12 +-
drivers/clk/clk-uclass.c | 68 +-
drivers/clk/imx/clk-gate2.c | 4 +-
drivers/clk/imx/clk-imx8mp.c | 2 +-
drivers/clk/kendryte/Kconfig | 12 +
drivers/clk/kendryte/Makefile | 1 +
drivers/clk/kendryte/bypass.c | 270 ++++++++
drivers/clk/kendryte/clk.c | 489 ++++++++++++++
drivers/clk/kendryte/pll.c | 601 ++++++++++++++++++
drivers/core/Kconfig | 7 +
drivers/core/Makefile | 1 +
drivers/core/read.c | 2 +-
drivers/core/simple-pm-bus.c | 56 ++
drivers/cpu/riscv_cpu.c | 39 +-
drivers/pinctrl/broadcom/pinctrl-bcm283x.c | 2 +-
drivers/pinctrl/mediatek/pinctrl-mtk-common.c | 2 +-
drivers/reset/Kconfig | 5 +
drivers/reset/Makefile | 1 +
drivers/reset/reset-syscon.c | 80 +++
include/configs/sipeed-maix.h | 24 +
include/dm/read.h | 4 +-
include/dt-bindings/clock/k210-sysctl.h | 59 ++
include/dt-bindings/mfd/k210-sysctl.h | 38 ++
include/dt-bindings/reset/k210-sysctl.h | 38 ++
include/kendryte/bypass.h | 31 +
include/kendryte/clk.h | 35 +
include/kendryte/pll.h | 57 ++
include/linux/clk-provider.h | 9 +
include/test/export.h | 16 +
lib/hashtable.c | 8 +-
test/dm/Makefile | 3 +
test/dm/k210_pll.c | 96 +++
test/dm/simple-pm-bus.c | 45 ++
test/dm/syscon-reset.c | 58 ++
70 files changed, 3673 insertions(+), 288 deletions(-)
create mode 100644 arch/riscv/dts/k210-maix-bit.dts
create mode 100644 arch/riscv/dts/k210.dtsi
create mode 100644 board/sipeed/maix/Kconfig
create mode 100644 board/sipeed/maix/MAINTAINERS
create mode 100644 board/sipeed/maix/Makefile
create mode 100644 board/sipeed/maix/maix.c
create mode 100644 configs/sipeed_maix_bitm_defconfig
create mode 100644 doc/board/sipeed/index.rst
create mode 100644 doc/board/sipeed/maix.rst
create mode 100644 doc/device-tree-bindings/bus/simple-pm-bus.txt
create mode 100644 doc/device-tree-bindings/mfd/kendryte,k210-sysctl.txt
create mode 100644 doc/device-tree-bindings/reset/syscon-reset.txt
create mode 100644 drivers/clk/kendryte/Kconfig
create mode 100644 drivers/clk/kendryte/Makefile
create mode 100644 drivers/clk/kendryte/bypass.c
create mode 100644 drivers/clk/kendryte/clk.c
create mode 100644 drivers/clk/kendryte/pll.c
create mode 100644 drivers/core/simple-pm-bus.c
create mode 100644 drivers/reset/reset-syscon.c
create mode 100644 include/configs/sipeed-maix.h
create mode 100644 include/dt-bindings/clock/k210-sysctl.h
create mode 100644 include/dt-bindings/mfd/k210-sysctl.h
create mode 100644 include/dt-bindings/reset/k210-sysctl.h
create mode 100644 include/kendryte/bypass.h
create mode 100644 include/kendryte/clk.h
create mode 100644 include/kendryte/pll.h
create mode 100644 include/test/export.h
create mode 100644 test/dm/k210_pll.c
create mode 100644 test/dm/simple-pm-bus.c
create mode 100644 test/dm/syscon-reset.c
--
2.25.1
More information about the U-Boot
mailing list