[PATCH v6 00/12] ClearFog Base static variant support

Joel Johnson mrjoel at lixil.net
Mon Mar 23 21:21:28 CET 2020

This patch series adds support for ClearFog Base static configuration,
as well as updating and fixing the ClearFog support for MMC and SPI

v2 changes:
  - updated against, and dependent on, https://patchwork.ozlabs.org/cover/1200324
v3 changes:
  - rebased against ClearFog runtime TLV EEPROM changes merged into mvebu/master
  - adjust static SerDes configuration at runtime instead of #ifdef
  - distinguish build-only config changes (SFP and PCIe/SATA) from
    runtime detectable config changes
  - retested SATA mode in PCIe slot with swap rx changes, confirmed
    working as presently patched. Only tested with ClearFog Base which
    only provides single channel, but Pro mechanism is parallel.
  - address minor review feedback

Joel Johnson (12):
  arm: mvebu: fix SerDes table alignment
  arm: mvebu: solidrun: remove hardcoded DTS MAC address
  arm: mvebu: clearfog: use Pro name by default
  arm: mvebu: clearfog: initial ClearFog Base variant
  arm: mvebu: clearfog: Add option for 2.5 Gbps SFP
  arm: mvebu: clearfog: Add SATA mode flags
  arm: mvebu: clearfog: Unify DT selection paths
  arm: mvebu: clearfog: add SPI offsets
  arm: mvebu: enable working default boot support
  arm: mvebu: clearfog: move ENV params to Kconfig
  arm: mvebu: clearfog: don't always use SPL MMC
  arm: mvebu: clearfog: Use Pro DT by default

 .../arm/dts/armada-38x-solidrun-microsom.dtsi |  1 -
 arch/arm/mach-mvebu/Kconfig                   | 13 ++++
 .../serdes/a38x/high_speed_env_spec.c         |  6 +-
 board/solidrun/clearfog/Kconfig               | 62 +++++++++++++++++++
 board/solidrun/clearfog/clearfog.c            | 61 +++++++++++++++---
 configs/clearfog_defconfig                    |  4 --
 include/configs/clearfog.h                    |  1 -
 7 files changed, 132 insertions(+), 16 deletions(-)
 create mode 100644 board/solidrun/clearfog/Kconfig


More information about the U-Boot mailing list