[PATCH v3 14/29] acpi: Add a binding for ACPI settings in the device tree
Simon Glass
sjg at chromium.org
Tue Mar 31 01:12:50 CEST 2020
Devices need to report various identifiers in the ACPI tables. Rather than
hard-coding these in drivers it is typically better to put them in the
device tree.
Add a binding file to describe this.
Signed-off-by: Simon Glass <sjg at chromium.org>
---
Changes in v3:
- Add a pointer to information about acpi,compatible
- Change the example to ELAN
- Correct description of acpi,probed
- Drop hid-descr-addr
- Drop mention of PRIC
- Just add the device.txt binding file in this patch
- Rename acpi,desc to acpi,ddn
Changes in v2:
- Add the hid-over-i2c binding document
- Fix definition of HID
- Infer hid-over-i2c CID value
doc/device-tree-bindings/device.txt | 37 +++++++++++++++++++++++++++++
1 file changed, 37 insertions(+)
create mode 100644 doc/device-tree-bindings/device.txt
diff --git a/doc/device-tree-bindings/device.txt b/doc/device-tree-bindings/device.txt
new file mode 100644
index 00000000000..06c2b84b6d5
--- /dev/null
+++ b/doc/device-tree-bindings/device.txt
@@ -0,0 +1,37 @@
+Devices
+=======
+
+Device bindings are described by their own individual binding files.
+
+U-Boot provides for some optional properties which are documented here. See
+also hid-over-i2c.txt which describes HID devices. See also
+Documentation/firmware-guide/acpi/enumeration.rst in the Linux kernel for
+the acpi,compatible property.
+
+ - acpi,has-power-resource : (boolean) true if this device has a power resource.
+ This causes an ACPI PowerResource to be written containing the properties
+ provided by this binding, to describe how to handle powering the device up
+ and down using GPIOs
+ - acpi,compatible : compatible string to report
+ - acpi,ddn : Contains the string to use as the _DDN (DOS (Disk Operating
+ System) Device Name)
+ - acpi,hid : Contains the string to use as the HID (Hardware ID)
+ identifier _HID
+ - acpi,probed : Tells U-Boot to add 'linux,probed' to the ACPI tables so that
+ Linux will only load the driver if the device can be detected (e.g. on I2C
+ bus)
+ - acpi,uid : _UID value for device
+
+
+Example
+-------
+
+elan_touchscreen: elan-touchscreen at 10 {
+ compatible = "i2c-chip";
+ reg = <0x10>;
+ acpi,hid = "ELAN0001";
+ acpi,ddn = "ELAN Touchscreen";
+ interrupts-extended = <&acpi_gpe GPIO_21_IRQ
+ IRQ_TYPE_EDGE_FALLING>;
+ acpi,probed;
+};
--
2.26.0.rc2.310.g2932bb562d-goog
More information about the U-Boot
mailing list