[PATCH 10/13] imx: load calibration parameters from fuse for i.MX8MP

[Fabio Estevam]

Hi Peng and Ye Li,

On Sun, May 3, 2020 at 10:57 AM Peng Fan <peng.fan at nxp.com> wrote:
>
> From: Ye Li <ye.li at nxp.com>
>
> i.MX8MP thermal which has two probes and supports temperature range
> from -40 to 125.  The driver still uses default 1p HW
> calibration at 25C and loads calibration parameters from fuse.
>
> Reviewed-by: Peng Fan <peng.fan at nxp.com>
> Signed-off-by: Ye Li <ye.li at nxp.com>
> Signed-off-by: Peng Fan <peng.fan at nxp.com>

Are you able to boot an NXP 5.4.3 kernel on a i.MX8MP EVK board?

I am getting a kernel hang right after the serial console is probed:
https://pastebin.com/3AtvJqWS

Any suggestions?

I am using ATF from 5.4.3, firmware version is 8.6 and I pass 'export
ATF_LOAD_ADDR=0x960000'.

Any ideas?

Thanks