[PATCH v3 04/12] phy: atheros: Explicitly disable RGMII delays

Michael Walle michael at walle.cc
Wed May 6 21:14:51 CEST 2020


From: Vladimir Oltean <vladimir.oltean at nxp.com>

To eliminate any doubts about the out-of-reset value of the PHY, that
the driver previously relied on.

If bisecting shows that this commit breaks your board you probably have
a wrong PHY interface mode. You probably want the
PHY_INTERFACE_MODE_RGMII_RXID or PHY_INTERFACE_MODE_RGMII_ID mode.

Signed-off-by: Vladimir Oltean <vladimir.oltean at nxp.com>
Acked-by: Joe Hershberger <joe.hershberger at ni.com>
---
 drivers/net/phy/atheros.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/net/phy/atheros.c b/drivers/net/phy/atheros.c
index 1da18eb5d4..3e59c3f391 100644
--- a/drivers/net/phy/atheros.c
+++ b/drivers/net/phy/atheros.c
@@ -70,10 +70,14 @@ static int ar8031_config(struct phy_device *phydev)
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID ||
 	    phydev->interface == PHY_INTERFACE_MODE_RGMII_ID)
 		ar803x_enable_tx_delay(phydev, true);
+	else
+		ar803x_enable_tx_delay(phydev, false);
 
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID ||
 	    phydev->interface == PHY_INTERFACE_MODE_RGMII_ID)
 		ar803x_enable_rx_delay(phydev, true);
+	else
+		ar803x_enable_rx_delay(phydev, false);
 
 	phydev->supported = phydev->drv->features;
 
@@ -96,10 +100,14 @@ static int ar8035_config(struct phy_device *phydev)
 	if ((phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) ||
 	    (phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID))
 		ar803x_enable_tx_delay(phydev, true);
+	else
+		ar803x_enable_tx_delay(phydev, false);
 
 	if ((phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) ||
 	    (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID))
 		ar803x_enable_rx_delay(phydev, true);
+	else
+		ar803x_enable_rx_delay(phydev, false);
 
 	phydev->supported = phydev->drv->features;
 
-- 
2.20.1



More information about the U-Boot mailing list