[PATCH 2/5] serial: sh: Improve FIFO empty check on RX

Marek Vasut marek.vasut at gmail.com
Sat May 9 22:37:59 CEST 2020


If the SCIF is receiving data quickly enough, it may happen that the
SCxSR_RDxF flag is cleared in sh_serial_getc_generic(), while the
FIFO still contains data. If that happens, the serial_getc_check()
reports no data in the FIFO as the flag is no longer set. Add one
more check, if the SCxSR_RDxF is not set, read out the FIFO level
and if there are still characters in the FIFO, permit reading them
out.

Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com>
Cc: Nobuhiro Iwamatsu <iwamatsu at nigauri.org>
---
 drivers/serial/serial_sh.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/serial/serial_sh.c b/drivers/serial/serial_sh.c
index acfcc2954a..0a4dfdc377 100644
--- a/drivers/serial/serial_sh.c
+++ b/drivers/serial/serial_sh.c
@@ -115,7 +115,10 @@ static int serial_getc_check(struct uart_port *port)
 		handle_error(port);
 	if (sci_in(port, SCLSR) & SCxSR_ORER(port))
 		handle_error(port);
-	return status & (SCIF_DR | SCxSR_RDxF(port));
+	status &= (SCIF_DR | SCxSR_RDxF(port));
+	if (status)
+		return status;
+	return scif_rxfill(port);
 }
 
 static int sh_serial_getc_generic(struct uart_port *port)
-- 
2.25.1



More information about the U-Boot mailing list