[PATCH 1/2] mmc: sdhci: Use debug for not supported SDMA info message

[Peng Fan]

> Subject: [PATCH 1/2] mmc: sdhci: Use debug for not supported SDMA info
> message
> 
> From: Matthias Brugger <mbrugger at suse.com>
> 
> If CONFIG_MMC_SDHCI_SDMA is enabled but the HW could not support it,
> we no longer error out. Instead we do not enable it in the host.
> Change the output from printf to debug as this isn't an error but only
> additional information now.
> 
> Signed-off-by: Matthias Brugger <mbrugger at suse.com>
> ---
> 
>  drivers/mmc/sdhci.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c index
> 6e8f6e3d17..8bb4393ce1 100644
> --- a/drivers/mmc/sdhci.c
> +++ b/drivers/mmc/sdhci.c
> @@ -744,8 +744,8 @@ int sdhci_setup_cfg(struct mmc_config *cfg, struct
> sdhci_host *host,
>  	if ((caps & SDHCI_CAN_DO_SDMA)) {
>  		host->flags |= USE_SDMA;
>  	} else {
> -		printf("%s: Your controller doesn't support SDMA!!\n",
> -		       __func__);
> +		debug("%s: Your controller doesn't support SDMA!!\n",
> +		      __func__);
>  	}
>  #endif
>  #if CONFIG_IS_ENABLED(MMC_SDHCI_ADMA)
> --

Reviewed-by: Peng Fan <peng.fan at nxp.com>