[PATCH v2 0/3] boards: ls1088aqds: transition to CONFIG_DM_ETH

[Ioana Ciornei]

This patch set targets to add support for CONFIG_DM_ETH for the NXP
LS1088AQDS board.

The main focus is on changing the DTS based on the SERDES protocol used.
In order to accomplish this, the MULTI_DTB_FIT feature is employed and
the appropriate DTS is chosed on boot from a list of predefined files.

Any unnecessary configurations made for the DPAA2 ethernet devices in
the board files are compiled out when CONFIG_DM_ETH is enabled. This is
because any information necessary is available in its associated DTS
node.

This patch set depends on another series that adds support for DM_ETH in
the ldpaa_eth driver and the RDB boards:
 https://patchwork.ozlabs.org/project/uboot/list/?series=165158&state=*

For the moment, when CONFIG_DM_ETH is enabled DPAA2 networking is
supported only for the SERDES block #1 protocol 21 (0x15) and protocol
29 (0x1d).

Changes in v2:
 - rebased on top of u-boot-fsl-qoriq/next

Ioana Ciornei (3):
  arm: dts: ls1088aqds: add CONFIG_MULTI_DTB_FIT support
  board: ls1088aqds: transition to DM_ETH
  configs: ls1088aqds_tfa_defconfig: enable DM_ETH and related

 arch/arm/dts/Makefile                    |   2 +
 arch/arm/dts/fsl-ls1088a-qds-21-x.dts    |  16 ++
 arch/arm/dts/fsl-ls1088a-qds-29-x.dts    |  16 ++
 arch/arm/dts/fsl-ls1088a-qds-sd1-21.dtsi |  30 ++++
 arch/arm/dts/fsl-ls1088a-qds-sd1-29.dtsi |  19 +++
 arch/arm/dts/fsl-ls1088a-qds.dts         | 123 +--------------
 arch/arm/dts/fsl-ls1088a-qds.dtsi        | 186 +++++++++++++++++++++++
 board/freescale/ls1088a/eth_ls1088aqds.c |  89 +++++++++++
 configs/ls1088aqds_tfa_defconfig         |   8 +
 9 files changed, 369 insertions(+), 120 deletions(-)
 create mode 100644 arch/arm/dts/fsl-ls1088a-qds-21-x.dts
 create mode 100644 arch/arm/dts/fsl-ls1088a-qds-29-x.dts
 create mode 100644 arch/arm/dts/fsl-ls1088a-qds-sd1-21.dtsi
 create mode 100644 arch/arm/dts/fsl-ls1088a-qds-sd1-29.dtsi
 create mode 100644 arch/arm/dts/fsl-ls1088a-qds.dtsi

-- 
2.17.1