[PATCH v1 00/15] add basic driver support for broadcom NS3 soc

[Rayagonda Kokatanur]

This is the second patch set series prepared on top of the
first patch set ("add initial support for broadcom NS3 soc").

This patch set will add following,
-dt nodes and defconfig options for basic device like pinctrl,
 gpio, mmc, qspi, wdt, i2c and pcie.
-start wdt service
-Enable GPT commands
-Enable EXT4 and FAT fs support

Pramod Kumar (2):
  arm: dts: ns3: add emmc node
  arm: dts: ns3: add sp805 watchdog node

Rayagonda Kokatanur (12):
  configs: ns3: enable pinctrl driver
  dt-bindings: pinctrl: add ns3 pads definition
  arm: dts: ns3: add pinctrl node
  arm: dts: ns3: add gpio node
  configs: ns3: enable BCM IPROC mmc driver
  configs: ns3: enable mmc commands
  arm: dts: ns3: add qspi node
  arm: dts: ns3: add i2c node
  configs: ns3: enable gpt commands
  configs: ns3: enable EXT4 and FAT fs support
  configs: ns3: enable sp805 watchdog driver
  board: ns3: start sp805 watchdog service

Srinath Mannam (1):
  arm: dts: ns3: add PAXB PCIe host and phy node

 arch/arm/dts/ns3-board.dts                    |  58 ++++
 arch/arm/dts/ns3-pinctrl.dtsi                 | 321 ++++++++++++++++++
 arch/arm/dts/ns3.dtsi                         | 224 ++++++++++++
 board/broadcom/bcmns3/ns3.c                   |  56 +++
 configs/bcm_ns3_defconfig                     |  19 ++
 .../dt-bindings/pinctrl/brcm,pinctrl-ns3.h    |  41 +++
 6 files changed, 719 insertions(+)
 create mode 100644 arch/arm/dts/ns3-pinctrl.dtsi
 create mode 100644 include/dt-bindings/pinctrl/brcm,pinctrl-ns3.h

-- 
2.17.1