[PATCH v1 00/15] add basic driver support for broadcom NS3 soc

[Rayagonda Kokatanur]

On Tue, May 19, 2020 at 11:01 PM Tom Rini <trini at konsulko.com> wrote:
>
> On Tue, May 19, 2020 at 10:39:49PM +0530, Rayagonda Kokatanur wrote:
> > Hi Tom,
> >
> >
> > On Tue, May 19, 2020 at 12:46 AM Tom Rini <trini at konsulko.com> wrote:
> > >
> > > On Sun, May 17, 2020 at 01:49:30PM +0530, Rayagonda Kokatanur wrote:
> > >
> > > > This is the second patch set series prepared on top of the
> > > > first patch set ("add initial support for broadcom NS3 soc").
> > > >
> > > > This patch set will add following,
> > > > -dt nodes and defconfig options for basic device like pinctrl,
> > > >  gpio, mmc, qspi, wdt, i2c and pcie.
> > > > -start wdt service
> > > > -Enable GPT commands
> > > > -Enable EXT4 and FAT fs support
> > >
> > > All of the dts changes not in a -u-boot.dtsi file either come from
> > > mainline Linux or at least linux-next and have had some level upstream
> > > review, right?  Thanks!
> >
> > Yes. All the DTS changes are merged in the Linux and are available at
> > arch/arm64/boot/dts/broadcom/stingray/
>
> Great.  Please reference the release you're taking these from as that
> will make future resyncs easier.  Thanks!

It's Linux v5.6.

Best regards,
Rayagonda

>
>
> --
> Tom