[PATCH 03/30] net: eepro100: Use plain debug()

[Ramon Fried]

On Sat, May 23, 2020 at 7:40 PM Marek Vasut <marek.vasut at gmail.com> wrote:
>
> Convert all the ifdef DEBUG to plain debug(), no functional change.
>
> Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com>
> ---
>  drivers/net/eepro100.c | 15 ++++-----------
>  1 file changed, 4 insertions(+), 11 deletions(-)
>
> diff --git a/drivers/net/eepro100.c b/drivers/net/eepro100.c
> index 503c44af4c..dd902386b1 100644
> --- a/drivers/net/eepro100.c
> +++ b/drivers/net/eepro100.c
> @@ -13,8 +13,6 @@
>  #include <miiphy.h>
>  #include <linux/delay.h>
>
> -#undef DEBUG
> -
>  /* Ethernet chip registers. */
>  #define SCBStatus              0       /* Rx/Command Unit Status *Word* */
>  #define SCBIntAckByte          1       /* Rx/Command Unit STAT/ACK byte */
> @@ -392,10 +390,8 @@ int eepro100_initialize (bd_t * bis)
>                 pci_read_config_dword (devno, PCI_BASE_ADDRESS_0, &iobase);
>                 iobase &= ~0xf;
>
> -#ifdef DEBUG
> -               printf ("eepro100: Intel i82559 PCI EtherExpressPro @0x%x\n",
> -                               iobase);
> -#endif
> +               debug("eepro100: Intel i82559 PCI EtherExpressPro @0x%x\n",
> +                     iobase);
>
>                 pci_write_config_dword (devno,
>                                         PCI_COMMAND,
> @@ -810,10 +806,7 @@ static void read_hw_addr (struct eth_device *dev, bd_t * bis)
>
>         if (sum != 0xBABA) {
>                 memset (dev->enetaddr, 0, ETH_ALEN);
> -#ifdef DEBUG
> -               printf ("%s: Invalid EEPROM checksum %#4.4x, "
> -                       "check settings before activating this device!\n",
> -                       dev->name, sum);
> -#endif
> +               debug("%s: Invalid EEPROM checksum %#4.4x, check settings before activating this device!\n",
> +                     dev->name, sum);
>         }
>  }
> --
> 2.25.1
>
Reviewed-By: Ramon Fried <rfried.dev at gmail.com