[PATCH v2 2/4] x86: apl: Add hex offsets for registers in FSP-M
Simon Glass
sjg at chromium.org
Wed May 27 13:42:12 CEST 2020
When comparing hex dumps it is useful to see the offsets of the registers.
Add them in where they correspond to a multiple of 16.
Possibly it would be useful to have a a command to output the FSP values
in human-readable form, making use of the fsp_bindings implementation.
Signed-off-by: Simon Glass <sjg at chromium.org>
---
Changes in v2:
- Correct the comment format
- Use 0x in register-offset comments
.../include/asm/arch-apollolake/fsp/fsp_m_upd.h | 17 +++++++++++++++--
1 file changed, 15 insertions(+), 2 deletions(-)
diff --git a/arch/x86/include/asm/arch-apollolake/fsp/fsp_m_upd.h b/arch/x86/include/asm/arch-apollolake/fsp/fsp_m_upd.h
index a77964f30c..5275b75f3b 100644
--- a/arch/x86/include/asm/arch-apollolake/fsp/fsp_m_upd.h
+++ b/arch/x86/include/asm/arch-apollolake/fsp/fsp_m_upd.h
@@ -34,7 +34,15 @@ struct __packed fsp_ram_channel {
u8 odt_levels;
};
+/**
+ * struct fsp_m_config - FSP-M configuration
+ *
+ * Note that headers precede this and are 64 bytes long. The hex offsets
+ * mentioned in this file are relative to the start of the header, the same
+ * convention used in Intel's APL FSP header file.
+ */
struct __packed fsp_m_config {
+ /* 0x40 */
u32 serial_debug_port_address;
u8 serial_debug_port_type;
u8 serial_debug_port_device;
@@ -49,6 +57,7 @@ struct __packed fsp_m_config {
u8 profile;
u8 memory_down;
+ /* 0x50 */
u8 ddr3_l_page_size;
u8 ddr3_lasr;
u8 scrambler_support;
@@ -62,6 +71,7 @@ struct __packed fsp_m_config {
u16 memory_size_limit;
u16 low_memory_max_value;
+ /* 0x60 */
u16 high_memory_max_value;
u8 disable_fast_boot;
u8 dimm0_spd_address;
@@ -73,6 +83,7 @@ struct __packed fsp_m_config {
u32 msg_level_mask;
u8 unused_upd_space0[4];
+ /* 0x110 */
u8 pre_mem_gpio_table_pin_num[4];
u32 pre_mem_gpio_table_ptr;
u8 pre_mem_gpio_table_entry_num;
@@ -81,8 +92,10 @@ struct __packed fsp_m_config {
u8 mrc_data_saving;
u32 oem_loading_base;
+ /* 0x120 */
u8 oem_file_name[16];
+ /* 0x130 */
void *mrc_boot_data_ptr;
u8 e_mmc_trace_len;
u8 skip_cse_rbp;
@@ -94,20 +107,20 @@ struct __packed fsp_m_config {
u8 msc1_wrap;
u32 msc0_size;
+ /* 0x140 */
u32 msc1_size;
u8 pti_mode;
u8 pti_training;
u8 pti_speed;
u8 punit_mlvl;
-
u8 pmc_mlvl;
u8 sw_trace_en;
u8 periodic_retraining_disable;
u8 enable_reset_system;
-
u8 enable_s3_heci2;
u8 unused_upd_space1[3];
+ /* 0x150 */
void *variable_nvs_buffer_ptr;
u8 reserved_fspm_upd[12];
};
--
2.27.0.rc0.183.gde8f92d652-goog
More information about the U-Boot
mailing list