[PATCH 06/13] usb: ehci-mx6: fix controller index for imx8m and imx8

[peng.fan at nxp.com]

From: Ye Li <ye.li at nxp.com>

The bind codes calculate the address offset for controller index, but
it is wrong for imx8m and imx8. It causes secondary controller fails to
work. So fix this problem, and also change all seq to req_seq.

There is another issue here for imx8, the codes use runtime CPU type check.
One iMX8, this check depends on IPC communication with SCFW, and need
MU driver been probed. But the usbotg is configured with "u-boot,dm_spl"
property for SDP download in SPL, so it will bind in early DM in u-boot
while the MU is not bound at same time, so the CPU type check will hang.
Fix it to use static check.

Signed-off-by: Ye Li <ye.li at nxp.com>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 drivers/usb/host/ehci-mx6.c | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
index 1db27949c6..96dcf7655b 100644
--- a/drivers/usb/host/ehci-mx6.c
+++ b/drivers/usb/host/ehci-mx6.c
@@ -665,7 +665,11 @@ static int ehci_usb_bind(struct udevice *dev)
 	 * With these changes in place, the ad-hoc indexing goes away and
 	 * the driver is fully converted to DT probing.
 	 */
-	u32 controller_spacing = is_mx7() ? 0x10000 : 0x200;
+	u32 controller_spacing;
+	if (IS_ENABLED(CONFIG_MX6))
+		controller_spacing = 0x200;
+	else
+		controller_spacing = 0x10000;
 	fdt_addr_t addr = devfdt_get_addr_index(dev, 0);
 
 	dev->req_seq = (addr - USB_BASE_ADDR) / controller_spacing;
@@ -692,7 +696,7 @@ static int ehci_usb_probe(struct udevice *dev)
 	}
 
 	priv->ehci = ehci;
-	priv->portnr = dev->seq;
+	priv->portnr = dev->req_seq;
 	priv->init_type = type;
 
 	ret = board_usb_init(priv->portnr, priv->init_type);
@@ -744,7 +748,7 @@ int ehci_usb_remove(struct udevice *dev)
 
 	ehci_deregister(dev);
 
-	return board_usb_cleanup(dev->seq, priv->init_type);
+	return board_usb_cleanup(dev->req_seq, priv->init_type);
 }
 
 static const struct udevice_id mx6_usb_ids[] = {
-- 
2.28.0