[PATCH 07/13] usb: ehci-mx6: Enable iMX EHCI driver for iMX8M Nano

peng.fan at nxp.com peng.fan at nxp.com
Wed Sep 16 14:56:59 CEST 2020


From: Ye Li <ye.li at nxp.com>

Add the IMX8MN to the EHCI-MX7 kconfig dependency.

Signed-off-by: Ye Li <ye.li at nxp.com>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 drivers/usb/host/Kconfig    | 2 +-
 drivers/usb/host/ehci-mx6.c | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 1e2c5006d4..36eb1138c4 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -147,7 +147,7 @@ config USB_EHCI_MX6
 
 config USB_EHCI_MX7
 	bool "Support for i.MX7 on-chip EHCI USB controller"
-	depends on ARCH_MX7 || IMX8MM
+	depends on ARCH_MX7 || IMX8MM || IMX8MN
 	default y
 	---help---
 	  Enables support for the on-chip EHCI controller on i.MX7 SoCs.
diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
index 96dcf7655b..ca015ef2f3 100644
--- a/drivers/usb/host/ehci-mx6.c
+++ b/drivers/usb/host/ehci-mx6.c
@@ -598,7 +598,7 @@ static int ehci_usb_phy_mode(struct udevice *dev)
 			plat->init_type = USB_INIT_DEVICE;
 		else
 			plat->init_type = USB_INIT_HOST;
-	} else if (is_mx7() || is_imx8mm()) {
+	} else if (is_mx7() || is_imx8mm() || is_imx8mn()) {
 		phy_status = (void __iomem *)(addr +
 					      USBNC_PHY_STATUS_OFFSET);
 		val = readl(phy_status);
-- 
2.28.0



More information about the U-Boot mailing list