[PATCH] arm64: a37xx: pci: Disable link training when unloading driver
Stefan Roese
sr at denx.de
Thu Sep 24 12:39:41 CEST 2020
On 22.09.20 13:21, Pali Rohár wrote:
> As required by PCI Express spec a delay for at least 100ms after
> de-asserting PERST# signal is needed before link training is enabled.
>
> Linux kernels prior to 5.8 version do not automatically disable link
> training before de-asserting PERST# signal, therefore this requirement is
> not fulfilled.
>
> Above requirement is needed for proper detection of some Compex PCIe WiFi
> cards. Otherwise Linux kernel cannot detect it.
>
> To allow using those PCIe cards with older Linux kernel versions booted by
> U-Boot compiled with U-Boot a37xx pci driver, disable link training in
> U-Boot when unloading this pci driver.
>
> Thanks to DM_FLAG_OS_PREPARE flag, U-Boot automatically unload this driver
> when booting Linux kernel.
>
> Signed-off-by: Pali Rohár <pali at kernel.org>
Applied to u-boot-marvell/master
Thanks,
Stefan
> ---
> drivers/pci/pci-aardvark.c | 5 +++++
> 1 file changed, 5 insertions(+)
>
> diff --git a/drivers/pci/pci-aardvark.c b/drivers/pci/pci-aardvark.c
> index b2c417701f..babb84ca93 100644
> --- a/drivers/pci/pci-aardvark.c
> +++ b/drivers/pci/pci-aardvark.c
> @@ -647,10 +647,15 @@ static int pcie_advk_probe(struct udevice *dev)
> static int pcie_advk_remove(struct udevice *dev)
> {
> struct pcie_advk *pcie = dev_get_priv(dev);
> + u32 reg;
>
> if (dm_gpio_is_valid(&pcie->reset_gpio))
> dm_gpio_set_value(&pcie->reset_gpio, 1);
>
> + reg = advk_readl(pcie, PCIE_CORE_CTRL0_REG);
> + reg &= ~LINK_TRAINING_EN;
> + advk_writel(pcie, reg, PCIE_CORE_CTRL0_REG);
> +
> return 0;
> }
>
>
More information about the U-Boot
mailing list