[PATCH v2 10/10] spi: dw: Support clock stretching

[Sean Anderson]

We don't always read/write to the FIFO fast enough. Enable clock stretching
for enhanced SPI transfers. This is only possible with DWC SSI devices more
recent than 1.01a. We also need to set the RXFTLR register to tell the
device when to start reciving again. In particular, the default of 0 will
result in the device never restarting reception if there is an overflow. On
the transmit side, we need to set CTRL1 so that the device knows when to
keep stretching the clock if the FIFO is empty.

Signed-off-by: Sean Anderson <seanga2 at gmail.com>
---

(no changes since v1)

 drivers/spi/designware_spi.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/designware_spi.c b/drivers/spi/designware_spi.c
index 64a3a8556b..44fb679fdb 100644
--- a/drivers/spi/designware_spi.c
+++ b/drivers/spi/designware_spi.c
@@ -258,6 +258,7 @@ static u32 dw_spi_update_spi_cr0(const struct spi_mem_op *op)
 	       | FIELD_PREP(SPI_CTRLR0_ADDR_L_MASK, op->addr.nbytes * 2)
 	       | FIELD_PREP(SPI_CTRLR0_INST_L_MASK, INST_L_8)
 	       | FIELD_PREP(SPI_CTRLR0_WAIT_CYCLES_MASK, wait_cycles)
+	       | SPI_CTRLR0_CLK_STRETCH_EN;
 }
 
 static int request_gpio_cs(struct udevice *bus)
@@ -360,6 +361,9 @@ static void spi_hw_init(struct udevice *bus, struct dw_spi_priv *priv)
 		priv->fifo_len = (fifo == 1) ? 0 : fifo;
 		dw_write(priv, DW_SPI_TXFTLR, 0);
 	}
+
+	/* Set receive fifo interrupt level register for clock stretching */
+	dw_write(priv, DW_SPI_RXFTLR, priv->fifo_len - 1);
 }
 
 /*
@@ -782,8 +786,7 @@ static int dw_spi_exec_op(struct spi_slave *slave, const struct spi_mem_op *op)
 
 	dw_write(priv, DW_SPI_SSIENR, 0);
 	dw_write(priv, DW_SPI_CTRLR0, cr0);
-	if (read)
-		dw_write(priv, DW_SPI_CTRLR1, op->data.nbytes - 1);
+	dw_write(priv, DW_SPI_CTRLR1, op->data.nbytes - 1);
 	if (priv->spi_frf != CTRLR0_SPI_FRF_BYTE)
 		dw_write(priv, DW_SPI_SPI_CTRL0, spi_cr0);
 	dw_write(priv, DW_SPI_SSIENR, 1);
-- 
2.31.0