[PATCH v2 10/17] ARM: dts: k3-j721e: Add the entries required for USB3 support on USB0

[Kishon Vijay Abraham I]

Partially sync with Linux's dts to add the entries required for USB3
support on USB0.
Note that the default mode is still "peripheral" not "host". USB3 is
supported only for the host mode.

Signed-off-by: Jean-Jacques Hiblot <jjhiblot at ti.com>
Signed-off-by: Vignesh Raghavendra <vigneshr at ti.com>
Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
---
 .../k3-j721e-common-proc-board-u-boot.dtsi    | 19 ++++++++++++++++++-
 1 file changed, 18 insertions(+), 1 deletion(-)

diff --git a/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi b/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi
index 3384ed9f3a..3b2e40c13d 100644
--- a/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi
+++ b/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi
@@ -115,13 +115,17 @@
 	u-boot,dm-spl;
 };
 
+&wiz3_pll1_refclk {
+	assigned-clocks = <&wiz3_pll1_refclk>, <&wiz3_pll0_refclk>;
+	assigned-clock-parents = <&k3_clks 295 0>, <&k3_clks 295 9>;
+};
+
 &main_usbss0_pins_default {
 	u-boot,dm-spl;
 };
 
 &usbss0 {
 	u-boot,dm-spl;
-	ti,usb2-only;
 };
 
 &usb0 {
@@ -193,3 +197,16 @@
 &mcu_fss0_ospi1_pins_default {
 	u-boot,dm-spl;
 };
+
+&wiz3_pll1_refclk {
+	assigned-clocks = <&wiz3_pll1_refclk>, <&wiz3_pll0_refclk>;
+	assigned-clock-parents = <&k3_clks 295 0>, <&k3_clks 295 9>;
+};
+
+&serdes_ln_ctrl {
+	u-boot,mux-autoprobe;
+};
+
+&usb_serdes_mux {
+	u-boot,mux-autoprobe;
+};
-- 
2.17.1