[PATCH 2/2] configs: imx8mn_beacon: Enable QSPI Support

[sbabic at denx.de]

> There is a QSPI chip connected to the FSPI.  Enable the defconfig
> to support it.
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> diff --git a/configs/imx8mn_beacon_defconfig b/configs/imx8mn_beacon_defconfig
> index d6a3385d8d..567a6e5e1e 100644
> --- a/configs/imx8mn_beacon_defconfig
> +++ b/configs/imx8mn_beacon_defconfig
> @@ -49,6 +49,7 @@ CONFIG_CMD_GPIO=y
>  CONFIG_CMD_I2C=y
>  CONFIG_CMD_MMC=y
>  CONFIG_CMD_PART=y
> +CONFIG_CMD_SPI=y
>  CONFIG_CMD_DHCP=y
>  CONFIG_CMD_MII=y
>  CONFIG_CMD_PING=y
> @@ -90,11 +91,14 @@ CONFIG_MMC_UHS_SUPPORT=y
>  CONFIG_MMC_HS400_ES_SUPPORT=y
>  CONFIG_MMC_HS400_SUPPORT=y
>  CONFIG_FSL_USDHC=y
> +CONFIG_MTD=y
> +CONFIG_DM_MTD=y
>  CONFIG_DM_SPI_FLASH=y
>  CONFIG_SF_DEFAULT_MODE=0
>  CONFIG_SF_DEFAULT_SPEED=40000000
>  CONFIG_SPI_FLASH_BAR=y
>  CONFIG_SPI_FLASH_STMICRO=y
> +CONFIG_SPI_FLASH_MTD=y
>  CONFIG_PHYLIB=y
>  CONFIG_PHY_ATHEROS=y
>  CONFIG_DM_ETH=y
> @@ -116,6 +120,7 @@ CONFIG_DM_SERIAL=y
>  CONFIG_MXC_UART=y
>  CONFIG_SPI=y
>  CONFIG_DM_SPI=y
> +CONFIG_NXP_FSPI=y
>  CONFIG_SYSRESET=y
>  CONFIG_SYSRESET_PSCI=y
>  CONFIG_DM_THERMAL=y
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================