[PATCH v4 03/12] pinctrl: single: fix offset management

[Dario Binacchi]

The pinmux configuration DT node of a peripheral does not define a
physical address but an offset. Only by adding it to the base address of
the controller it is possible to calculate the physical address of the
register to be configured. Printing an offset also requires a different
formatting option than a physical address.

Signed-off-by: Dario Binacchi <dariobin at libero.it>
Reviewed-by: Pratyush Yadav <p.yadav at ti.com>

---

(no changes since v3)

Changes in v3:
- Added Pratyush Yadav review tag.

 drivers/pinctrl/pinctrl-single.c | 24 ++++++++++++++----------
 1 file changed, 14 insertions(+), 10 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-single.c b/drivers/pinctrl/pinctrl-single.c
index 49ed15211d..935b5e920d 100644
--- a/drivers/pinctrl/pinctrl-single.c
+++ b/drivers/pinctrl/pinctrl-single.c
@@ -77,15 +77,17 @@ static int single_configure_pins(struct udevice *dev,
 	struct single_pdata *pdata = dev_get_plat(dev);
 	int n, count = size / sizeof(struct single_fdt_pin_cfg);
 	phys_addr_t reg;
-	u32 val;
+	u32 offset, val;
 
 	for (n = 0; n < count; n++, pins++) {
-		reg = fdt32_to_cpu(pins->reg);
-		if ((reg < 0) || (reg > pdata->offset)) {
-			dev_dbg(dev, "  invalid register offset 0x%pa\n", &reg);
+		offset = fdt32_to_cpu(pins->reg);
+		if (offset < 0 || offset > pdata->offset) {
+			dev_dbg(dev, "  invalid register offset 0x%x\n",
+				offset);
 			continue;
 		}
-		reg += pdata->base;
+
+		reg = pdata->base + offset;
 		val = fdt32_to_cpu(pins->val) & pdata->mask;
 		switch (pdata->width) {
 		case 16:
@@ -111,15 +113,17 @@ static int single_configure_bits(struct udevice *dev,
 	struct single_pdata *pdata = dev_get_plat(dev);
 	int n, count = size / sizeof(struct single_fdt_bits_cfg);
 	phys_addr_t reg;
-	u32 val, mask;
+	u32 offset, val, mask;
 
 	for (n = 0; n < count; n++, pins++) {
-		reg = fdt32_to_cpu(pins->reg);
-		if ((reg < 0) || (reg > pdata->offset)) {
-			dev_dbg(dev, "  invalid register offset 0x%pa\n", &reg);
+		offset = fdt32_to_cpu(pins->reg);
+		if (offset < 0 || offset > pdata->offset) {
+			dev_dbg(dev, "  invalid register offset 0x%x\n",
+				offset);
 			continue;
 		}
-		reg += pdata->base;
+
+		reg = pdata->base + offset;
 
 		mask = fdt32_to_cpu(pins->mask);
 		val = fdt32_to_cpu(pins->val) & mask;
-- 
2.17.1