[PATCH 2/7] board: ge: bx50v3: add phy reset GPIO

[Sebastian Reichel]

Add PHY's reset GPIO, so that U-Boot does a PHY hard reset.
This is needed, since the PHY might become unresponsive if
watchdog reboots the system while a transaction is ongoing.

The reset GPIO is added to the U-Boot specific DT files, since
the kernel does not setup the reserved registers correctly after
resetting the PHY and thus must not reset it.

Signed-off-by: Sebastian Reichel <sebastian.reichel at collabora.com>
---
 arch/arm/dts/imx6q-bx50v3-uboot.dtsi | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm/dts/imx6q-bx50v3-uboot.dtsi b/arch/arm/dts/imx6q-bx50v3-uboot.dtsi
index 2de3b850ec8a..b54e8e6ada74 100644
--- a/arch/arm/dts/imx6q-bx50v3-uboot.dtsi
+++ b/arch/arm/dts/imx6q-bx50v3-uboot.dtsi
@@ -35,3 +35,15 @@
 		};
 	};
 };
+
+/*
+ * This is not done in imx6q-ba16.dtsi, since that file is shared
+ * with the kernel and the kernel should not reset the PHY, since
+ * it lacks support for configuring the reserved registeres to
+ * avoid a board specific voltage peak issue.
+ */
+&fec {
+	phy-reset-gpios = <&gpio1 28 GPIO_ACTIVE_LOW>;
+	phy-reset-duration = <1>;
+	phy-reset-post-delay = <0>;
+};
-- 
2.30.2