[RFC PATCH v8 4/5] rockchip: px30: add support for SFC for Odroid Go Advance

Jon Lin jon.lin at rock-chips.com
Thu Aug 12 16:06:51 CEST 2021


From: Chris Morgan <macromorgan at hotmail.com>

The Odroid Go Advance uses a Rockchip Serial Flash Controller with an
XT25F128B SPI NOR flash chip. This adds support for both. Note that
while both the controller and chip support quad mode, only two lines
are connected to the chip. Changing the pinctrl to bus2 and setting tx
and rx lines to 2 for this reason.

Signed-off-by: Chris Morgan <macromorgan at hotmail.com>
Signed-off-by: Jon Lin <jon.lin at rock-chips.com>
---

Changes in v8:
- Change to use tx single line to make a good compatible
- Change spiflash dts node

 arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi | 17 +++++++++++++++++
 arch/arm/dts/rk3326-odroid-go2.dts         | 16 ++++++++++++++++
 2 files changed, 33 insertions(+)

diff --git a/arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi b/arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi
index 00767d2abd..0990005a15 100644
--- a/arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi
+++ b/arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi
@@ -7,6 +7,15 @@
 	chosen {
 		u-boot,spl-boot-order = &sdmmc;
 	};
+
+	aliases {
+		i2c0 = &i2c0;
+		i2c1 = &i2c1;
+		mmc0 = &sdmmc;
+		serial1 = &uart1;
+		serial2 = &uart2;
+		spi0 = &sfc;
+	};
 };
 
 &cru {
@@ -57,6 +66,14 @@
 	u-boot,spl-fifo-mode;
 };
 
+&sfc {
+	u-boot,dm-pre-reloc;
+};
+
+&{/sfc at ff3a0000/flash at 0} {
+	u-boot,dm-pre-reloc;
+};
+
 &uart1 {
 	clock-frequency = <24000000>;
 	u-boot,dm-pre-reloc;
diff --git a/arch/arm/dts/rk3326-odroid-go2.dts b/arch/arm/dts/rk3326-odroid-go2.dts
index 8cd4688c49..3866cc6612 100644
--- a/arch/arm/dts/rk3326-odroid-go2.dts
+++ b/arch/arm/dts/rk3326-odroid-go2.dts
@@ -617,6 +617,22 @@
 	status = "okay";
 };
 
+&sfc {
+	pinctrl-0 = <&sfc_clk &sfc_cs &sfc_bus2>;
+	pinctrl-names = "default";
+	#address-cells = <1>;
+	#size-cells = <0>;
+	status = "okay";
+
+	flash at 0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		spi-max-frequency = <108000000>;
+		spi-rx-bus-width = <2>;
+		spi-tx-bus-width = <1>;
+	};
+};
+
 &tsadc {
 	status = "okay";
 };
-- 
2.17.1





More information about the U-Boot mailing list