[PATCH u-boot-marvell 14/29] tools: kwboot: Print new line after SPL output

[Marek Behún]

There is no separation between output from the code from binary header
(U-Boot SPL in most cases) and subsequent kwboot output.

Print '\n' to make distinguishing these two easier.

Signed-off-by: Marek Behún <marek.behun at nic.cz>
---
 tools/kwboot.c | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/tools/kwboot.c b/tools/kwboot.c
index 2829b74a2e..2e16db83fa 100644
--- a/tools/kwboot.c
+++ b/tools/kwboot.c
@@ -385,6 +385,7 @@ static int
 kwboot_xm_sendblock(int fd, struct kwboot_block *block, int allow_non_xm,
 		    int *done_print)
 {
+	int non_xm_print = 0;
 	int rc, retries;
 	char c;
 
@@ -413,6 +414,7 @@ kwboot_xm_sendblock(int fd, struct kwboot_block *block, int allow_non_xm,
 			if (!_is_xm_reply(c) && allow_non_xm) {
 				putchar(c);
 				fflush(stdout);
+				non_xm_print = 1;
 			}
 		} while (!_is_xm_reply(c));
 
@@ -420,6 +422,9 @@ kwboot_xm_sendblock(int fd, struct kwboot_block *block, int allow_non_xm,
 			kwboot_progress(-1, '+');
 	} while (c == NAK && retries-- > 0);
 
+	if (non_xm_print)
+		kwboot_printv("\n");
+
 	rc = -1;
 
 	switch (c) {
-- 
2.31.1