[RESEND PATCH 12/16] arm: omap3: Compile lowlevel_init() function only when it is used

[Marek Vasut]

On 2/6/21 4:45 PM, Pali Rohár wrote:
> On Saturday 06 February 2021 16:40:18 Marek Vasut wrote:
>> On 2/5/21 8:12 PM, Pali Rohár wrote:
>>> Function lowlevel_init() is called only from cpu_init_crit() and this
>>> function is wrapped into #if .. #endif section. So compile also
>>> lowlevel_init() function under same #if condition.
>>>
>>> Signed-off-by: Pali Rohár <pali at kernel.org>
>>> ---
>>>    arch/arm/mach-omap2/omap3/lowlevel_init.S | 6 +++++-
>>>    1 file changed, 5 insertions(+), 1 deletion(-)
>>>
>>> diff --git a/arch/arm/mach-omap2/omap3/lowlevel_init.S b/arch/arm/mach-omap2/omap3/lowlevel_init.S
>>> index 2a05b5e521..4fa89418a1 100644
>>> --- a/arch/arm/mach-omap2/omap3/lowlevel_init.S
>>> +++ b/arch/arm/mach-omap2/omap3/lowlevel_init.S
>>> @@ -45,7 +45,7 @@ ENDPROC(do_omap3_emu_romcode_call)
>>>    ENTRY(cpy_clk_code)
>>>    	/* Copy DPLL code into SRAM */
>>>    	adr	r0, go_to_speed		/* copy from start of go_to_speed... */
>>> -	adr	r2, lowlevel_init	/* ... up to start of low_level_init */
>>> +	adr	r2, go_to_speed_end	/* ... up to start of go_to_speed_end */
>>>    next2:
>>>    	ldmia	r0!, {r3 - r10}		/* copy from source address [r0] */
>>>    	stmia	r1!, {r3 - r10}		/* copy to   target address [r1] */
>>> @@ -167,8 +167,11 @@ pll_div_add5:
>>>    pll_div_val5:
>>>    	.word CLSEL1_EMU_VAL
>>> +go_to_speed_end:
>>>    #endif
>>
>> This hunk above seems like an unrelated change ^ ?
> 
> Entry 'lowlevel_init' is defined 3 lines below and is available only
> when !CONFIG_SKIP_LOWLEVEL_INIT && !CONFIG_SKIP_LOWLEVEL_INIT_ONLY.
> 
> Few lines above is code which copies DPLL code into SRAM and this code
> ends at address where 'lowlevel_init' entry starts.
> 
> Entry 'cpy_clk_code' is compiled also when CONFIG_SKIP_LOWLEVEL_INIT is
> defined, therefore it is required to define label which is outside of
> the #if code defined below and ends after the 'go_to_speed' code.
> 
> So I defined a new 'go_to_speed_end' label to allow compiling
> 'cpy_clk_code' entry when CONFIG_SKIP_LOWLEVEL_INIT is defined.

Can you add exactly this description to the commit message -- the change 
isn't immediately obviously, collect the RBs and resend the patchset, so 
it can be picked ?

Thanks