[PATCH 1/2] imx8mm_beacon: Enable QSPI Support

[sbabic at denx.de]

> There is a QSPI chip connected to the FSPI.  Enable the defconfig
> to support it.
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> Reviewed-by: Peng Fan <peng.fan at nxp.com>
> diff --git a/configs/imx8mm_beacon_defconfig b/configs/imx8mm_beacon_defconfig
> index 49d5453078..2970e5dc71 100644
> --- a/configs/imx8mm_beacon_defconfig
> +++ b/configs/imx8mm_beacon_defconfig
> @@ -41,6 +41,7 @@ CONFIG_CMD_GPIO=y
>  CONFIG_CMD_I2C=y
>  CONFIG_CMD_MMC=y
>  CONFIG_CMD_PART=y
> +CONFIG_CMD_SPI=y
>  CONFIG_CMD_DHCP=y
>  CONFIG_CMD_MII=y
>  CONFIG_CMD_PING=y
> @@ -78,6 +79,14 @@ CONFIG_MMC_HS400_ES_SUPPORT=y
>  CONFIG_MMC_HS400_SUPPORT=y
>  CONFIG_SPL_MMC_HS400_SUPPORT=y
>  CONFIG_FSL_USDHC=y
> +CONFIG_MTD=y
> +CONFIG_DM_MTD=y
> +CONFIG_DM_SPI_FLASH=y
> +CONFIG_SF_DEFAULT_MODE=0x0
> +CONFIG_SF_DEFAULT_SPEED=10000000
> +CONFIG_SPI_FLASH_BAR=y
> +CONFIG_SPI_FLASH_STMICRO=y
> +CONFIG_SPI_FLASH_MTD=y
>  CONFIG_PHYLIB=y
>  CONFIG_PHY_ATHEROS=y
>  CONFIG_DM_ETH=y
> @@ -102,7 +111,6 @@ CONFIG_DM_SERIAL=y
>  CONFIG_MXC_UART=y
>  CONFIG_SPI=y
>  CONFIG_DM_SPI=y
> -CONFIG_SPI_MEM=y
>  CONFIG_NXP_FSPI=y
>  CONFIG_SYSRESET=y
>  CONFIG_SPL_SYSRESET=y
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================