[PATCH 6/9] board: phytec: phycore_imx8mp: Set VDD_ARM to 0,95V

[Teresa Remmet]

Increase VDD_ARM to prevent timing issues as VDD_SOC is
used in OD mode. Also increase GIC clock.

Signed-off-by: Teresa Remmet <t.remmet at phytec.de>
---
 board/phytec/phycore_imx8mp/spl.c | 11 ++++++++++-
 configs/phycore-imx8mp_defconfig  |  1 +
 2 files changed, 11 insertions(+), 1 deletion(-)

diff --git a/board/phytec/phycore_imx8mp/spl.c b/board/phytec/phycore_imx8mp/spl.c
index 0bc4c7693b06..815ca9badcba 100644
--- a/board/phytec/phycore_imx8mp/spl.c
+++ b/board/phytec/phycore_imx8mp/spl.c
@@ -62,7 +62,8 @@ int power_init_board(void)
 	/* BUCKxOUT_DVS0/1 control BUCK123 output */
 	pmic_reg_write(p, PCA9450_BUCK123_DVS, 0x29);
 
-	/* increase VDD_SOC to typical value 0.95V */
+	/* Increase VDD_SOC and VDD_ARM to OD voltage 0.95V */
+	pmic_reg_write(p, PCA9450_BUCK1OUT_DVS0, 0x1C);
 	pmic_reg_write(p, PCA9450_BUCK2OUT_DVS0, 0x1C);
 
 	/* set WDOG_B_CFG to cold reset */
@@ -71,6 +72,14 @@ int power_init_board(void)
 	return 0;
 }
 
+void spl_board_init(void)
+{
+	/* Set GIC clock to 500Mhz for OD VDD_SOC. */
+	clock_enable(CCGR_GIC, 0);
+	clock_set_target_val(GIC_CLK_ROOT, CLK_ROOT_ON | CLK_ROOT_SOURCE_SEL(5));
+	clock_enable(CCGR_GIC, 1);
+}
+
 int board_fit_config_name_match(const char *name)
 {
 	return 0;
diff --git a/configs/phycore-imx8mp_defconfig b/configs/phycore-imx8mp_defconfig
index a22f5e089d97..89c2ac977f47 100644
--- a/configs/phycore-imx8mp_defconfig
+++ b/configs/phycore-imx8mp_defconfig
@@ -25,6 +25,7 @@ CONFIG_OF_SYSTEM_SETUP=y
 CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/imx8m/imximage-8mp-lpddr4.cfg"
 CONFIG_DEFAULT_FDT_FILE="oftree"
 CONFIG_BOARD_LATE_INIT=y
+CONFIG_SPL_BOARD_INIT=y
 CONFIG_SPL_BOOTROM_SUPPORT=y
 CONFIG_SPL_SYS_MALLOC_SIMPLE=y
 CONFIG_SPL_SEPARATE_BSS=y
-- 
2.25.1