[PATCHv5 19/26] arm: mach-k3: do board config for PM only if supported

[Tero Kristo]

From: Tero Kristo <t-kristo at ti.com>

If the raw PM support is built in, we are operating in the split
firmware approach mode where PM support is not available. In this
case, skip the board config for this.

Signed-off-by: Tero Kristo <t-kristo at ti.com>
Signed-off-by: Tero Kristo <kristo at kernel.org>
---
 arch/arm/mach-k3/sysfw-loader.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c
index 0bacfc4d07..c6af205163 100644
--- a/arch/arm/mach-k3/sysfw-loader.c
+++ b/arch/arm/mach-k3/sysfw-loader.c
@@ -159,11 +159,13 @@ static void k3_sysfw_configure_using_fit(void *fit,
 		      ret);
 
 	/* Apply power/clock (PM) specific configuration to SYSFW */
+#ifndef CONFIG_K3_DM_FW
 	ret = board_ops->board_config_pm(ti_sci,
 					 (u64)(u32)cfg_fragment_addr,
 					 (u32)cfg_fragment_size);
 	if (ret)
 		panic("Failed to set board PM configuration (%d)\n", ret);
+#endif
 
 	/* Extract resource management (RM) specific configuration from FIT */
 	ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM,
-- 
2.17.1