[PATCH v2] arm: imx: imx8mm: correct unrecognized fracpll frequency

[sbabic at denx.de]

> Frequency requested by ddrphy_init_set_dfi_clk from fracpll uses MHZ()
> macro, which expands the value provided to the Hz range without taking into
> account the precise Hz setting. This causes the frequency of 266 MHz not ot
> be found in the imx8mm_fracpll_tbl, since it is entered there with a
> precise Hz value. This in turn causes the boot hang in SPL, as proper DDR
> fracpll frequency cannot be determined.
> Correct the value in imx8mm_fracpll_tbl to match the one expanded by
> MHZ(266) macro, rounding it down to MHz range only.
> Signed-off-by: Andrey Zhizhikin <andrey.zhizhikin at leica-geosystems.com>
> Cc: Stefano Babic <sbabic at denx.de>
> Cc: Fabio Estevam <festevam at gmail.com>
> Cc: "NXP i.MX U-Boot Team" <uboot-imx at nxp.com>
> Cc: Peng Fan <peng.fan at nxp.com>
> Cc: Simon Glass <sjg at chromium.org>
> Cc: Ye Li <ye.li at nxp.com>
> Fixes: 825ab6b406 ("driver: ddr: Refine the ddr init driver on imx8m")
> Reviewed-by: Fabio Estevam <festevam at gmail.com>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================