[PATCHv6 19/26] arm: mach-k3: do board config for PM only if supported

[Tero Kristo]

From: Tero Kristo <t-kristo at ti.com>

If the raw PM support is built in, we are operating in the split
firmware approach mode where PM support is not available. In this
case, skip the board config for this.

Signed-off-by: Tero Kristo <t-kristo at ti.com>
Signed-off-by: Tero Kristo <kristo at kernel.org>
---
 arch/arm/mach-k3/sysfw-loader.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c
index 0bacfc4d07..41449db89d 100644
--- a/arch/arm/mach-k3/sysfw-loader.c
+++ b/arch/arm/mach-k3/sysfw-loader.c
@@ -159,11 +159,13 @@ static void k3_sysfw_configure_using_fit(void *fit,
 		      ret);
 
 	/* Apply power/clock (PM) specific configuration to SYSFW */
+#if !CONFIG_IS_ENABLED(K3_DM_FW)
 	ret = board_ops->board_config_pm(ti_sci,
 					 (u64)(u32)cfg_fragment_addr,
 					 (u32)cfg_fragment_size);
 	if (ret)
 		panic("Failed to set board PM configuration (%d)\n", ret);
+#endif
 
 	/* Extract resource management (RM) specific configuration from FIT */
 	ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM,
-- 
2.17.1