[PATCH 06/11] imx: ventana: put PFUZ100 regulators in continuous mode

[Tim Harvey]

In the default 'auto' mode regulators that are very lightly loaded
can be put in PFM mode and fail to regulator properly. Switching them
to always use continuous PWM mode has a neglibable affect on system
power and garuntees proper regulation under lightly loaded circumstances.

Signed-off-by: Tim Harvey <tharvey at gateworks.com>
---
 board/gateworks/gw_ventana/common.c | 26 ++++++++++++++++++++++++++
 1 file changed, 26 insertions(+)

diff --git a/board/gateworks/gw_ventana/common.c b/board/gateworks/gw_ventana/common.c
index 9f5f20f781..b5a0162c5e 100644
--- a/board/gateworks/gw_ventana/common.c
+++ b/board/gateworks/gw_ventana/common.c
@@ -1596,6 +1596,32 @@ void setup_pmic(void)
 				pmic_reg_write(p, PFUZE100_VGEN6VOL, reg);
 			}
 		}
+
+		/* put all switchers in continuous mode */
+		pmic_reg_read(p, PFUZE100_SW1ABMODE, &reg);
+		reg &= ~(SW_MODE_MASK);
+		reg |= PWM_PWM;
+		pmic_reg_write(p, PFUZE100_SW1ABMODE, reg);
+
+		pmic_reg_read(p, PFUZE100_SW2MODE, &reg);
+		reg &= ~(SW_MODE_MASK);
+		reg |= PWM_PWM;
+		pmic_reg_write(p, PFUZE100_SW2MODE, reg);
+
+		pmic_reg_read(p, PFUZE100_SW3AMODE, &reg);
+		reg &= ~(SW_MODE_MASK);
+		reg |= PWM_PWM;
+		pmic_reg_write(p, PFUZE100_SW3AMODE, reg);
+
+		pmic_reg_read(p, PFUZE100_SW3BMODE, &reg);
+		reg &= ~(SW_MODE_MASK);
+		reg |= PWM_PWM;
+		pmic_reg_write(p, PFUZE100_SW3BMODE, reg);
+
+		pmic_reg_read(p, PFUZE100_SW4MODE, &reg);
+		reg &= ~(SW_MODE_MASK);
+		reg |= PWM_PWM;
+		pmic_reg_write(p, PFUZE100_SW4MODE, reg);
 	}
 
 	/* configure LTC3676 PMIC */
-- 
2.17.1