[PATCH 5/6] drivers: net: fsl_enetc: require a PHY device when probing

[Vladimir Oltean]

Given that even a fixed-link has an associated phy_device, there is no
reason to operate in a mode when dm_eth_phy_connect fails.

Remove the driver checks for a NULL priv->phy and just return -ENODEV
when that happens.

Signed-off-by: Vladimir Oltean <vladimir.oltean at nxp.com>
---
 drivers/net/fsl_enetc.c | 13 +++++--------
 1 file changed, 5 insertions(+), 8 deletions(-)

diff --git a/drivers/net/fsl_enetc.c b/drivers/net/fsl_enetc.c
index f6fc7801b95b..5961775024ff 100644
--- a/drivers/net/fsl_enetc.c
+++ b/drivers/net/fsl_enetc.c
@@ -281,21 +281,20 @@ static void enetc_start_pcs(struct udevice *dev)
 }
 
 /* Configure the actual/external ethernet PHY, if one is found */
-static void enetc_config_phy(struct udevice *dev)
+static int enetc_config_phy(struct udevice *dev)
 {
 	struct enetc_priv *priv = dev_get_priv(dev);
 	int supported;
 
 	priv->phy = dm_eth_phy_connect(dev);
-
 	if (!priv->phy)
-		return;
+		return -ENODEV;
 
 	supported = PHY_GBIT_FEATURES | SUPPORTED_2500baseX_Full;
 	priv->phy->supported &= supported;
 	priv->phy->advertising &= supported;
 
-	phy_config(priv->phy);
+	return phy_config(priv->phy);
 }
 
 /*
@@ -335,9 +334,8 @@ static int enetc_probe(struct udevice *dev)
 	dm_pci_clrset_config16(dev, PCI_COMMAND, 0, PCI_COMMAND_MEMORY);
 
 	enetc_start_pcs(dev);
-	enetc_config_phy(dev);
 
-	return 0;
+	return enetc_config_phy(dev);
 }
 
 /*
@@ -550,8 +548,7 @@ static int enetc_start(struct udevice *dev)
 
 	enetc_setup_mac_iface(dev);
 
-	if (priv->phy)
-		phy_startup(priv->phy);
+	phy_startup(priv->phy);
 
 	return 0;
 }
-- 
2.25.1