[PATCH 2/2] usb: ehci-mx6: Do not fail when 'reg' is not found

[Fabio Estevam]

Hi Marek,

On Sun, Jun 20, 2021 at 5:11 PM Marek Vasut <marex at denx.de> wrote:

> I applied both, but this looks very much like mx8mm which also uses
> nop-phy . So I think what would be even nicer is if you could try and
> enable CONFIG_PHY , patch the DT to specify phys = <&usbphynop1>;
> instead of fsl,usbphy = <&usbphynop1>; and see whether that works. You
> can have a look at how the usb was enabled on the verdin board.
>
> Maybe then we can get rid of some of those ifdefs and switch to generic
> EHCI PHY etc.

I will follow these suggestions after 2021.07 is out, thanks.