[PATCH v10 13/27] mtd: spi-nor-core: Do not set data direction when there is no data

[Pratyush Yadav]

Even when spi_nor_write_reg() has no data to write, like when executing
a write enable operation, it sets the data direction to
SPI_MEM_DATA_OUT. This trips up spi_mem_check_buswidth() because it
expects a data phase when there is none. Make sure the data direction is
set to SPI_MEM_NO_DATA when there is no data to write.

Signed-off-by: Pratyush Yadav <p.yadav at ti.com>
---
 drivers/mtd/spi/spi-nor-core.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/mtd/spi/spi-nor-core.c b/drivers/mtd/spi/spi-nor-core.c
index 24c6b8c4a3..d795ecbc9f 100644
--- a/drivers/mtd/spi/spi-nor-core.c
+++ b/drivers/mtd/spi/spi-nor-core.c
@@ -209,6 +209,9 @@ static int spi_nor_write_reg(struct spi_nor *nor, u8 opcode, u8 *buf, int len)
 					  SPI_MEM_OP_NO_DUMMY,
 					  SPI_MEM_OP_DATA_OUT(len, NULL, 1));
 
+	if (len == 0)
+		op.data.dir = SPI_MEM_NO_DATA;
+
 	return spi_nor_read_write_reg(nor, &op, buf);
 }
 
-- 
2.30.0