[PATCH 00/17] arm: mach-k3: Initial Support for Texas Instruments AM642 Platform

[Lokesh Vutla]

On 23/04/21 9:57 pm, Dave Gerlach wrote:
> Hi,
> 
> This series adds initial support for the latest new SoC, AM642,
> from Texas Instruments.
> 
> Additional detail can be found in the patch descriptions, also
> see AM64X Technical Reference Manual (SPRUIM2, Revised Jan 2021)
> for further details: https://www.ti.com/lit/pdf/spruim2
> 
> Regards,
> Dave
> 
> Dave Gerlach (14):
>   arm: mach-k3: Add basic support for AM642 SoC definition
>   arm: mach-k3: am642: Unlock all applicable control MMR registers
>   arm: mach-k3: am642: Store boot info from ROM
>   arm: mach-k3: am642: Load SYSFW binary and config from boot media
>   arm: mach-k3: am642: Use mmc start and stop callbacks
>   mmc: sdhci_am654: Add Support for TI's AM642 SoC
>   mailbox: k3-sec-proxy: Extend valid thread IDs
>   board: ti: am64x: Add board support for am64x evm
>   dt-bindings: pinctrl: k3: Introduce pinmux definitions for AM64
>   arm: dts: ti: Add Support for AM642 SoC
>   arm: dts: k3-am642: Add initial support for EVM
>   arm: dts: k3-am642: Add r5 specific dt support
>   configs: am64x_evm_r5: Add Initial support
>   configs: am64x_evm_a53: Add Initial support

You need to add MAINTAINERS file under board/ti/am64x. Else few testes are failing.

https://source.denx.de/u-boot/custodians/u-boot-ti/-/pipelines/7397

Thanks and regards,
Lokesh