[PATCH] pinctrl: single: Fix probe failure getting register area size

[Vignesh Raghavendra]

If reg property of pinctrl-single node requires address translation then
probe fails with following message:

single-pinctrl pinctrl at 4301c000: failed to get base register size

This is because driver uses dev_read_addr_size() to get size which also
tries to fetch untranslated addr and fails.
Fix this by using dev_read_addr_size_index() which takes care of address
translation and also makes following dev_read_addr() call redundant.

This fixes Ethernet failures on TI's AM654 based EVMs due to lack of
pinmux configuration.

Fixes: 9fd8a430f3 ("pinctrl: single: get register area size by device API")
Signed-off-by: Vignesh Raghavendra <vigneshr at ti.com>
---
 drivers/pinctrl/pinctrl-single.c | 10 ++--------
 1 file changed, 2 insertions(+), 8 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-single.c b/drivers/pinctrl/pinctrl-single.c
index ebb7602dde..7af6c5f0b0 100644
--- a/drivers/pinctrl/pinctrl-single.c
+++ b/drivers/pinctrl/pinctrl-single.c
@@ -509,19 +509,13 @@ static int single_of_to_plat(struct udevice *dev)
 		return -EINVAL;
 	}
 
-	addr = dev_read_addr_size(dev, "reg", &size);
+	addr = dev_read_addr_size_index(dev, 0, &size);
 	if (addr == FDT_ADDR_T_NONE) {
-		dev_err(dev, "failed to get base register size\n");
+		dev_err(dev, "failed to get base register address\n");
 		return -EINVAL;
 	}
 
 	pdata->offset = size - pdata->width / BITS_PER_BYTE;
-
-	addr = dev_read_addr(dev);
-	if (addr == FDT_ADDR_T_NONE) {
-		dev_dbg(dev, "no valid base register address\n");
-		return -EINVAL;
-	}
 	pdata->base = addr;
 
 	ret = dev_read_u32(dev, "pinctrl-single,function-mask", &pdata->mask);
-- 
2.31.1